Instruction manual

Instruction manual
20220513E 45
Turn the helm wheel to set the rudder tiller arm to
approximate center position.
Rotate the RF300 transmitter lever until it is also set to
center position. (A simple method is to line up the
transmitter lever to be opposite the cable entry into the
feedback.)
Figure 16 RF300 mounting
Attach the transmitter rod to the RF300. Set the RF300
mounting location to be in accordance with the figure
above. The center of the RF300 should be in line with the
center of the rudder post. Mount the RF300 to a suitable
platform using the screws provided. If necessary, add
blocking material under the RF300 to adjust the height of
the transmission arm to be level with the rudder tiller arm.
Note ! Due to space limitations, it may be necessary to cut the
length of the transmitter rod to move the RF300 closer to
the rudder post.
Tighten the mounting screws for both the RF300 feedback
unit and the transmitter rod ball joint.
Have someone observe the RF300 while someone else turns
the helm wheel through the complete range of travel from
full port to full stbd. rudder to verify that the mechanical
linkage to the RF300 is not obstructed.