Instruction manual

Instruction manual
20220513E 41
5. Sea trial settings (Page 76)
a. Rudder zero
b. Compass calibration
c. Compass (offset) adjustment
d. Automatic tuning (Optional, does not need to
be done)
e. Viewing parameters
6. Testing Autopilot Operation at Sea (refer to Sea Trial
instructions, Page 83)
7. Provide the user with training (Page 84)
3.3 Unpacking and handling
Care should be taken when unpacking and handling the
equipment. A visual inspection should be made to see that
the equipment has not been damaged during shipment and
that all components and parts are present according to the
packing list.
A standard scope of supply for an AP11 system will include:
• Control unit with standard installation accessories and 7
m (23') of cable.
• J3000X or J300X (optional) Junction Unit.
• RFC35 Fluxgate Compass with 15 m (49') cable attached.
• RF300 Feedback unit with 10 m (33') cable attached and
transmission rod.
• Appropriate drive unit for the installation (unless the
AP11 is going to operate an existing drive unit)
• Optional equipment that may have been ordered for
the installation.