Instruction manual

Instruction manual
20220513E 39
G
R
E
Y
G
R
E
E
N
P
I
N
K
Y
E
L
L
O
W
1K
1K
+12V
0V
REAR SIDE
The Demo mode is activated the following way:
• Turn on the power supply while the Port button is
pressed.
(Note: The demo unit can only be turned off by
switching off the supply)
• Keep the button pressed until the fault warning “Fail -
Data Comm” is shown.
• Reset the fault warning by pressing the Mode button.
You may now operate the AP11 in all modes without
activating any alarms or fault warnings. Please refer to
previous pages for operating instructions.
The Demo programme is simulating a boat sailing at a
speed of 10 knots. Initial heading is 000 (North).
Using the Port and Stbd buttons in Stby mode will
generate a rudder angle on the display and the heading
will change accordingly.
Course change, Dodge, U-turn etc. can be demonstrated in
Auto mode.
In Nav mode you can sail to a waypoint at a bearing of 270
degrees.
In Wind mode the wind is permanent from North.
You may also enter the Installation menus and go through
Dockside and Seatrial settings.