Instruction manual

Robertson AP11 Autopilot
38 20220513E
2.25 Alarms
The software program in the AP11 is continually monitoring
system input and output data as well as operational
functions of the system. Audible and visual alarms are given
in the event a failure is detected. The Heading Display will
show a flashing FAIL whilst the Mode Display below will
show an explaining text.
STBY-AUTO
PWR
RESPONSE TURN
MODE
DODGE
AUTOPILOT
ROBERTSON AP11
Rudder
The audible alarm is reset by pressing the Mode button or
by changing mode from e.g. AUTO to STBY. The visual
alarm will now display "Err." and alternate in 3 seconds
every 12 seconds with the operating display until the fault
has been rectified. Consult the Trouble Shooting section,
page 88 for hints and try to solve the problem yourself. If
the problem turns out to be too complicated, consult your
nearest Simrad Robertson dealer for assistance.
2.26 Demo mode
The software in the AP11 Control Unit also contains a
demo programme that enables a full demonstration of the
functions and features. All you need is a 12V DC power
supply and two 1K resistors connected as pr. figure; no
junction unit, compass or feedback is needed.