Instruction manual

Robertson AP11 Autopilot
18 20220513E
2.2 On/Off
A single push on the STBY-AUTO/PWR button switches the
AP11 Autopilot ON. The display will show STBY-COM and
display the boats heading.
A long press (3-5 seconds) on the STBY-AUTO/PWR button
switches the system OFF. As an additional safety, it is
recommended that you locate the power breaker or mains
switch before using the system for the first time.
2.3 Standby
The Standby mode is used for manual steering and
provides Non-Follow-Up electric steering on any control
head or a remote.
Note ! The AP11 autopilot will not process rudder commands
or allow access to the AUTO modes if the Dockside
settings in the Installation Setup has not been set
properly. The display will also flash NO DATA in STBY
NAV and STBY W/A if appropriate NMEA signals are
not available as input to the system.
You can cycle through the Standby mode displays and nav.
displays by a short press on the MODE button.
STBY COM
STBY NAV
STBY W/A
Nav. display no. 1:
Bearing and distance
to waypoint
Nav. display no. 2:
Cross Track Error (XTE)
and name of waypoint
STB Y- AUT O
PWR
RESPONSE TURN
MOD E
DODGE
AUTOPILOT
ROBERTSON AP11
STBY-AUTO
PWR
RESPONSE TURN
MOD E
DOD GE
AUTOPILOT
ROBERTSON AP11
STBY-AUTO
PWR
RESPONSE TURN
MODE
DODGE
AUTOPILOT
ROBERTSON AP11
Rudder
Ru dd e r
Ru dd e r