Instruction manual

Installation

20220505H 65

On-Off

Vsys+

JUNCTION UNIT

MAIN PCB

ROBNET

Bus+

Vsys

Alarm

Bn Gn

Bus

Pnk Gry

Yel

AP20

CONTROL UNIT

Figure 4-10 Control unit connection

HOW TO REMOVE PINS:

Extraction tool

Pull the wire

Insert tool in slot

Note ! For installations that require special cable length, contact your

Simrad distributor for information.

AP21 connection

If a Simrad AP21 is part of the system, use the Robnet connector

in a free receptacle (see Figure 4-9). Alternatively cut the

connector from the cable and connect the wires in parallel with

the cable shown on Figure 4-10 using the same colour code.

Note ! The AP21 cable contains an air-breathing tube. Check that the

tube is open after you have cut the cable.