Instruction manual

Cable layout

850-164696 / A

Figure 29 Standard

cable gland assembly

Compression nut

Cable

Gland body

Cabinet panel

Screen collarCompression seal

Screen

(CD3260)

4 Depending on whether the cable has already been installed

in conduits, either:

c (installed) measure the maximum length of cable

required to reach from the final cable clip outside the

cabinet to the terminal blocks inside the cabinet, add 20

cm, then remove the excess cable,

or:

d (loose cable) measure the maximum length of wire

required to reach from the cable gland to the terminal

blocks inside the cabinet, add 20 cm. and mark the cable.

Note The cable’s outer insulation will extend into the cable gland to a

point approximately 5 mm outside the outer surface o f the

cabinet wall into which the cable gland is secured.

5 Taking care not to damage the screening, carefully remove

the outer insulation from the required cable length.

6 Leaving 12 mm of the screen exposed from the insulation,

cut off the remainder.

7 Taking care not to damage the screening, slide the

compression nut (smallest diameter first) over the cable and

onto the intact insulation.

8 Taking care not to damage the screening, slide the

compression seal (rounded end first) over the cable and onto

the intact insulation.

9 Slide the screen collar (narrow end first) onto the cable and

fit it underneath the screen. Slide it as close to the intact outer

insulation as possible.

10 If the screen extends beyond the “flat” end of the screen

collar, fold any excess length over the end of the collar such

that the screen will be gripped between the collar and the

gland body when the parts are assembled.