Instruction manual

Cable layout
47
850-164696 / A
C29 - +12 Vdc
The +12 Vdc input/output connectors can be used in the
following ways:
• Operate the transceiver from a +12 Vdc power supply.
• Operate the transceiver from mains power, but leave a battery
connected to the DC connectors. The battery will then
provide you with an uninterruptable power supply facility. It
will automatically be charged when the mains power is
present.
• Use the +12 Vdc power from the transceiver to power
external units.
→ Cable details on page 64.
C30 - Transducer
The transducer cable is fixed to the transducer. The standard
transducer cable supplied is 20 meters long.
Note The transducer cable between the transducer GPT must be run
in steel conduits. Use flexible conduit close to the plug on the
transceiver.
→ Cable details on page 76.
GPT Connectors
The following connectors are located on the rear side of the
General Purpose Transceiver (GPT) unit.