Instruction manual

Cable layout
45
850-164696 / A
Single GPT cables
The cables shown and specified here are those used when the
EK60 is implemented with a stand-alone General Purpose
Transceiver (GPT) unit.
Note that the Auxiliary plug on the GPT provides several
interfaces that are not used with the EK60.
Figure 21 EK60 cable plan - Single GPT
SIMRAD GPT
C20 - Remote on/off
C2
3
- Synchronisation
C22 - Event*
C21 - New line*
C24 - Motion sensor
C2
5
- Temperature sensor*
C10 - Ethernet to Processing Unit
C30
Transducer
C28
A
C power
C29
+12 Vdc
C27
Ship's GND
(CD6939C)
Connections identified with an asterix (*) in the drawing have
not been implemented in the EK60 software.
C10 - Ethernet
This is the dedicated ethernet cable which connects the GPT
with the Processing Unit computer. With only a single GPT in
use, use a “cross-over” ethernet cable between the units.
Note Screened ethernet (CAT5 STP) must be used.
→ Cable details on page 65.