Installation manual

Simrad Echo sounder transducers
Cable gland for wood o r GRP hulls
A bronze cable gland kit is available for wood and GRP vessels.
(CD17008B)
A
B
B
B
C
C
C
D
E
F
(A) = Packing nipple. Make sure that y
ou do not damage the
transducer cable by tightening
the packing nipple too hard!
(B) = Washers
(C) = Rubber gaskets
(D) = Hole diameter 28 mm
(E) = Steel conduit
(F) = Cable to the echo sounder
(or a junction box)
The cable gland kit includes a
ll of the necessary parts needed to
install the unit except scr
ews.
Simrad recommends that a
one inch steel conduit (that the
transducer cable will b
e run through) with an inside threaded
diameter of three-qua
rter inches is attached to the gland’s packing
nipple. This connect
ion must be watertight, and the conduit must
extend to above the v
essel’s water line.
34
851-160164/H