Installation manual

Ways of mounting the transducer
Retractable transducer
Hull units allowing the transducer to be lowered and hoisted are
commonly used for horizontal looking sonars. When not in use,
the transducer is retracted into a trunk.
The retractable hull unit is more expensive than a blister, but on
vessels with a hull where it is difficult or impossible to install a
blister, it may still be worth while. The principles of a hull unit
with a retractable transducer is shown below.
Vessels without a keel and with a wide, flat bottom is an example
where a retractable hull unit can be the only acceptable method
for bringing the echo sounder transducer below the boundary
layer.
(CD017012E)
B
E
C
D
A
(A) = Transducer
(B) = Trunk
(C) = Transducer shaft
(D) = Transducer shaft sleeve
(E) = Keel
851-160164/H 31