Installation manual

Ways of mounting the transducer
Toe-in
The primary consideration must be to allow laminar water flow.
In most cases this is achieved by placing the transducer (A)
parallel with the keel (C). However, i f the transducer is located
close to the bow, the front of the transducer may have a few
degrees (5 to 8°) toe-in towards the bow. If you have a planing
hull, the toe-in must be 0°.
(CD017007D)
C
A
B
F
(A) = Transducer
(B) = 5 to 8° on deplacement hulls, 0° on planing hulls
(C) = Keel
(F) = Forward
851-160164/H 15