Installation manual

12 |
Introduction | AP70/AP80 Installation Manual
AC70 board
Drive computer board for rudder or propeller (i.e. Voith Schneider) for reversible motor or
galvanic non-isolated solenoids.
Includes:
• SUPPLY - power supply 12/24 V in
• DRIVE - output for Motor or solenoid command
• DRIVE ENGAGE - output for clutch/bypass valve or automode signal for oilspeed valve etc
• ALARM - Output for external alarm buzzer
• NMEA 0183 - in/out for IEC 61162-1, -2 and NMEA 0183
• RUDDER - Input for frequency rudder feedback
• REMOTE - Input for NFU steering lever
• SIMNET - connection to CAN network
D
RIV
E
30 A FU
S
E
PO
LARITY LED
S
DR
IV
E
EN
G
A
GE
S
UPPL
Y
N
MEA
0
1
83
SC
RE
EN
T
ERMINATI
ON
S
IMNE
T
R
UDD
ER
AD80 board
Drive computer board for rudder or thruster, supporting analog voltage or low current signals
for angle or proportional control.
Includes:
• UI CRTL - output for analog voltage low current command
• RUD UI - Input for analog (voltage or current) rudder feedback
• RUD FRQ - Input for frequency rudder feedback
• READY - output for ready contact when board is up running ready for control
• HS1 - Generic in/out handshake signal port 1
• HS2 - Generic in/out handshake signal port 2
• MODE - Input for external mode selector
• SIMNET - connection to CAN network
SI
MN
ET
HS1
U
I CRT
L
RU
D
UI
RUD FR
Q
RE
AD
Y
M
O
DE
U
IN
RAN
GE
U
C
TR
L
SC
REE
N
TERMINATI
ON
AC70
AC85
AD80
AC85
AC80A