Extra Information

| 11
AP70/AP80 | Addendum for sw release 1.2
Update to AP70/80 Installation manual
SG05 PRO
The SG05 PRO Autopilot Computer provides autopilot control from AP70 and AP80 control
units to CAN bus/EVC steering systems.
The SG05 PRO receives sensor data (drive/rudder angle and boat speed) from the EVC, does
steering calculations and sends drive/rudder commands back to the EVC system which brings
drive/rudder to commanded angle.
Installation
The SG05 PRO Autopilot Computer has 2 SimNet ports to connect either via a drop-cable or
inline as part of the network backbone.
For Micro-C based networks use the SimNet to Micro-C (male) converter cable p/n 24005729.
T
Compass
GPS
Sensor
AC80S / AC80A
1
12/24 V DC
T
Autopilot
Control unit
2
4
3
SG05 PRO
(000-11479-001)
SG05 PRO AC80A Kit
(
000-11483-001)
and
SG05 PRO AC80S Kit
(
000-11484-001)
CAN BUS
compatible
steering system
Thruster
control
Item Description
1 Micro-C backbone
2 Micro-C T-joiners
3 SimNet to Mircor-C (male) Drop cable
4 SD05 Cable, female
T
Terminators
¼ Notes:
- For IMO approval, the system must contain AC80S or AC80A Computer.
- You can have maximum two extra computers/drives in a SG05 PRO system
A separate Installation Guide if delivered with the SG05 unit.