Operation Manual

Operation | 11
Follow-Up steering (FU)
Not applicable for Virtual feedback configuration (page
74).
In the Follow-Up steering mode the course knob may be
used to set rudder commands. The commanded rudder
angle is shown on the display and the rudder will move to
the commanded angle and stop.
Press both buttons
simultaneously to
activate Follow-Up
Use course knob
to command
rudder angle
While in Follow-up mode you cannot take manual
control of the wheel.
STBY
Return to manual control in Standby by pressing the
STBY button.
Alternative displays in Standby mode
Alternating rudder angle bargraph
If your autopilot is driving a Simrad
MSD50 Stern Drive, the rudder
angle display will after turn-on
alternate between 10 degrees port
and starboard to indicate that the
(rudder) zero point need be set.
Refer to page 112 to set the zero point.