Operation Manual

Installation

20220505H 97

• Bring the boat up to cruising speed, and head directly into the

wind.

• If the boat has twin engines, synchronize the engine RPM's.

• Set the trim tabs and stabilizers to have no effect on the boats

heading.

• Steer the boat manually on a steady course.

• Confirm the rudder ZERO position by rotating the course

knob clockwise.

The display will then show:

Seatrial

Set Rudder zero

Confirmed 00

Compass

calibration

Compass offset ---

Heading 345

Automatic tuning

Yes

Press STBD [>] to proceed to next menu item.

Compass calibration

This function will activate the automatic compass calibration

procedure.

Note ! If an optional magnetic compass is installed and connected to a

CI300X, or if a GYRO compass, or other manufacturers fluxgate

is connected to a CI300X, it is still required to perform the

automatic compass calibration in order to calibrate the CI300X

Interface/input signal.

Before you begin the compass calibration procedure, make sure

you have enough open water around you to make a full

clockwise turn with the boat.

The calibration should be done in calm sea conditions and with

minimal wind to obtain good results. Use about 45-60 seconds to

make a full circle.