Operation Manual

Simrad AP20 Autopilot
22 20220505H
347
RFC
HEADING
NEXT WP
350
M
EGERSUND
nm
o
BRG
DST
348
o
o
CTS
nm
NAV
SETUP
Press again to
activate NAV mode
Display readout:
Course to steer: 348
Cross track error: .02 nm to stbd.
Compass heading: 347 M or T
Next waypoint: Egersund
Bearing to waypoint: 350
Distance to wa
yp
oint: 7.2 nm
* Course to steer is the course set internally in the autopilot to
steer the boat on to the track.
When operating the AP20 in NAV mode to automatically steer
through a route of waypoints, the AP20 will steer to the first
waypoint in the route after you accept the first waypoint as the
location to steer to. When you arrive at the waypoint, the AP20
will give an audible warning and display an alert screen with the
proposed new course information displayed. If the required
course change is more than 10° you will need to verify that the
upcoming course change is acceptable. Verification is performed
by pressing the NAV button after the alert screen is displayed. If
no verification is received, the AP20 will continue on the current
set course in AUTO mode.
Origin
Waypoint 2
New heading accepted
automatically after
NAV/SETUP button is pressed
Waypoint arrival zone
(determined by the navigator)
Waypoint 1
At the arrival of each new
waypoint in a route:
Regain manual steering
at any time by pressing:
STBY
PWR
NAV
SETUP
Verify course change greater
than 10 by pressing:
RFC
HEADING
NEXT WP
Fishing
nm
o
BRG
DST
WP Fishing
Brg.
Chg.
OK ? Press NAV
o
o
100
M
035
135