System information

Setup at installation | 71
Boat type
1
When the autopilot is configured for Virtual Feedback the
Boat type is automatically set to Outboard.
Virtual Feedback calibration
The Virtual feedback calibration is entered as a numerical
value equal to the physical rudder angle observed at the
hard over position.
1
1
Use the Up/Down keys to set correct value and confirm
with
MENU
.
Refer to pages
64-65 to set the Drive unit voltage and
the Drive Engage.
Rudder test
To perform the Virtual Feedback rudder test you must be
able to view the movement of the engines/drives
(“rudder”).
Activate the automatic rudder test as shown, following
the instructions on the display.
1
Confirm by pressing the softkey.
The next step is to enter the correct direction of the
rudder movement.