User Manual
#ONGRATULATIONS #ONTENTS Congratulations on the purchase of your new washing machine. We trust you will be delighted with it. Please read this instruction book carefully.
4HE DIFFERENT MODELS This booklet covers a range of different models. Check the model number on the control panel of your washer and then refer to the appropriate panel on this page and the next. MODELS 955 & 605 1 10 2 3 5 6 7 8 9 4 1 Digital display Displays program times see page 9. Displays other modes see page 9. 6 Lid locked Light ON, Lid LOCKED or Light OFF, Lid UNLOCKED see page 8. 2 Power Switches the power on and off see page 5. 7 Wash choice Changes wash time see page 7.
MODELS 902, 802 & 552 – Control panel shown is for models 802 & 552 1 10 2 3 5 6 7 8 9 4 1 &INISHED Indicates a wash program is finished. 2 3 4 5 6 Lid locked Light ON, Lid LOCKED or Light OFF, Lid UNLOCKED see page 8. Power Switches the power on and off see page 5. 7 Wash choice Changes wash time see page 7. Program selector Selects the wash program see page 6. 8 Water temperature Sets the temperature of the wash water see page 7.
)-0/24!.4 3!&%49 ).3425#4)/.3 Please read the user manual carefully and store in a handy place for later reference. Pass the user manual on to possible new owners of the washing machine.
7!4%2 3!6).' 4%#(./,/'9 If you have previously used a top load agitator type WASHER YOU NEED TO KNOW THAT YOUR NEW WASHER works differently. This washer uses much less water per load of washing, and does it by the two new technologies described below. 2ECIRCULATION In most wash and deep rinses the recirculation system is active and a recirculation pump runs to keep water at a low level in the outer bowl, and at a correct level in the washbowl. Recirculation saves 33% of wash and deep rinse water.
+./7).' 9/52 7!3().' -!#().% Draining the wash and deep rinse water At the end of the wash and deep rinse stages, the recirculation pump will stop. There will be a delay to allow water to flow through washbowl drain holes into the outer bowl. After the delay, the drain pump will start pumping water out through the drain hose and then the pump will stop.
7!3().' ).3425#4)/.3 /UT OF BALANCE INTERRUPTION The washing machine can stop during rinse and spin stages of a wash because of an out of balance condition. To let you know an out of balance interruption has happened, models 955 & 605 will show ‘ ’ in the digital display and for the other models all WATER TEMP lights will be flashing. If an out of balance occurs, the machine may stop spinning and then start spinning again to try and overcome the out of balance before alerting you with ‘beeping’.
!DD THE DETERGENT 1. 5SE /.,9 low sudsing front load washer detergent SUCH AS #OLD 0OWER FOR &RONT ,OADERS AND (IGH %FFICIENCY 4OP ,OADERS OR DETERGENTS LABELLED “Matic”. measuring out the amount recommended on the package. 2. Mix detergent in one litre of hot or warm water. 3. Add the pre-mixed detergent to the wash load. !DDING BLEACH "LEACHING OF CLOTHES CAN HELP TO REMOVE STAINS HEAVY SOILING AND to kill bacteria. /XYGEN TYPE This is generally a powder type bleach.
Starting your washing machine If the settings shown on the control panel are what you want to use and the Program SELECTOR is set to the correct wash program for your clothes load, press the START/PAUSE button to start your wash. To select a different program or change other settings, read the following instructions Choose the wash program Turn the Program SELECTOR knob to choose the wash program you want. The table “YOUR Program GUIDE” shown below will help you in selecting the right program.
Program times Fill 15% Recirculation wash 42% Drain & pre rinse spin 16% Eco rinse & final spin 27% 5+ final spin 15.5 mins 1 2 3 4 9 mins 25 mins 9.5 mins Choosing the wash water temperature For each wash program your washing machine automatically selects a suitable fill water temperature. If you want to use a different wash water temperature, press the WATER TEMP button repeatedly.The water temp lights will tell you the temperature for each press of the button.
5SING YOUR 7ASHING -ACHINE !UTO ,EVEL WATER LEVEL Using the Auto-Level water level option ensures just the right amount of water is used for the wash load. (Note: You can select a water level manually if you wish. See ‘Manual water level’ below). To select Auto-Level water fill, turn the WATER LEVEL knob to the Auto-Level position. When you start your wash, the machine will conduct a series of water fill and short agitations to determine the amount of water needed.
FEATURES OF YOUR WASHING MACHINE Additional features on your washing machine are described in this section. The display will also show codes for your information and guidance. (See below) Models with Digital Display The digital display will show the time in minutes (or hours and minutes) to complete the wash program. Information and guidance feature The washing machine will give you information by displaying codes in the Digital Display or by using the control panel lights and the ‘beeping’ function.
&EATURES OF YOUR 7ASHING -ACHINE 0ROGRESS INDICATOR ADVANCING THE WASH The washing machine has WASH, RINSE and SPIN Progress Indicator lights to let you know where the machine currently is within the wash program. You can advance to the next stage of the wash by holding the START/PAUSE button depressed until the next stage progress light comes on. Press the START/PAUSE button to store the setting you have chosen. 2INSE OPTIONS ECO and DEEP are the rinse options available to you on these models.
CARING FOR YOUR WASHING MACHINE Your washing machine will give you long and trouble-free service, if you follow the instructions in this section.These instructions show you how to care for your washing machine. 2. Unclip the filter bag from the column. 3. 4. Turn the bag inside out and remove the lint. Wash the filter bag and dispenser cup in hot water. 5. Reassemble the filter to the column and place it back in the centre of the agitator. What to do after you have finished your washing 1.
Caring for your Washing Machine How to replace the lid 1. Hold the lid in a vertical position. 2. Put the left hand hinge into the hinge hole of the top panel. 3. Put the right hand hinge into the hinge slot and close the lid.
+ELPFUL +,NTS ,N DEA/,NG :,T+ WAS+,NG PROBLEMS r esidues on washed items Some detergents have ingredients which do not fully dissolve and as a consequence, may leave white residue or particles evident on the surface of darker clothes in the finished wash load. Similarly some soils may not dissolve fully, resulting in residue evident on lighter coloured clothes. If you are experiencing residue on some clothes, the following tips will help: Check that recirculation filter is clean.
! '5)$% 4/ 34!). 2%-/6!, 7HITE COTTONS AND LINENS 7ASHABLE COLOURED FABRICS Ball point pen ink 3PONGE WITH METHYLATED SPIRIT "LEACH IF REQUIRED Same as for whites - use oxygen type bleach. Beetroot Rinse as soon as possible under cold water. "LEACH IF NECESSARY Same as for whites - use oxygen type bleach. "LOOD MEAT JUICE EGG DRY STAIN Cover area with meat tenderiser (msg). Apply warm water to make a paste. Wait 15-20 minutes. Sponge with cool water or with diluted bleach.
42/5",%3(//4).' Do not call for service until you have checked the points listed below. If you call for service and there is nothing wrong with your washing machine, you will have to pay for the service call. You will have to pay even when your washing machine is under warranty.
Troubleshooting /THER $IAGNOSTIC HELP AND A GUIDE FOR WHEN YOU SHOULD CALL FOR SERVICE If you are having a problem with your washing machine, make sure you have followed ALL of the instructions on this page and the previous page before calling for service. Diagnostic Help given by machine using DISPLAYS AND LIGHTS ACCOMPANIED BY @BEEPING Description &OR $IGITAL Display models Displayed Code Not filling with water &OR .ON $IGITAL Display models &LASHING ,IGHT S #USTOMER ACTION 3UMMARY $%%0 2).
Warranty FOR SALES IN AUSTRALIA AND NEW ZEALAND APPLIANCE: SIMPSON EZIsensor TOP LOADING WASHING MACHINE. 4HIS DOCUMENT SETS OUT THE TERMS AND CONDITIONS OF PRODUCT WARRANTIES FOR %LECTROLUX BRANDED APPLIANCES )T IS AN IMPORTANT document. Please keep it with your proof of purchase documents in a safe place for future reference should you REQUIRE SERVICE FOR YOUR %LECTROLUX APPLIANCE 'ENERAL 4ERMS AND #ONDITIONS 1.
For further information please call customer care on 1300 363 640 (AUS) or 09 573 2384 (NZ) or visit our websites at www.simpson.com.au or www.simpson.co.nz Simpson.We are a part of the Electrolux family. Share more of our thinking at www.electrolux.com P/No.
