7.
Contents / Customer Care And Service CONTENTS 1 2 3 4 5 6 7 8 9 10 11 12 SAFETY INFORMATION .............................................................................................. 3 PRODUCT DESCRIPTION ........................................................................................... 5 CONTROL PANEL ...................................................................................................... 6 BEFORE FIRST USE ....................................................................
Safety Information 1. 3 SAFETY INFORMATION Conditions of use This appliance is intended to be used in household and similar applications such as: - Farm houses - By clients in serviced apartments, holiday apartments and residential type environments. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings.
Safety Information After having installed the appliance, check that it is not standing on the inlet and drain hose and the worktop is not pressing the electrical supply cable. If the machine is situated on a carpeted floor, please adjust the feet in order to allow air to circulate freely. Always be sure, that there is no water leakage from hoses and their connections after the installation. Any plumbing work required to install this appliance should be carried out by a qualified plumber.
Product Description 5 2. PRODUCT DESCRIPTION Your new appliance meets all modern requirements for effective treatment of laundry with low water, energy and detergent consumption. The program selector dial combines the function of program and temperature selection, making it easier to set the program. The automatic cooling of the washing water from 90° to 60°C before draining will prevent old drain pipes from being deformed. The balance control device ensures the machine is stable during the spin.
Product Description / Control Panel Accessories Plastic caps Spanner To close the holes on the rear side of the cabinet after the removal of the transit bolts. - To remove the transit bolts. - To adjust levelling legs. Plastic hose guide To connect the drain hose on the edge of a sink. 3.
Control Panel 3.1 Program Selector Knob Turn this knob to set a wash program, the machine will automatically select the spin speed and temperature for selected program. The selector knob can be turned either clockwise or anticlockwise. Position “ ” to reset program/ switching OFF the machine. At the end of the program the selector dial must be turned to position “ ”, to switch the machine off. 3.
Control Panel 3.8 Start/Pause Button To start the selected program, press the ‘Start/Pause’. To interrupt a program which is running, press the ‘Start/Pause’ to pause the machine. To restart the program from the point at which it was interrupted, press the ‘Start/Pause’ again. If you have chosen a delayed start, after pressing ‘Start/Pause’ the machine will begin the countdown. 3.
Control Panel 3.11 Programs + Options Program; Temperature Type of load; Max. weight of load Cycle description Cottons; 90 °C to Cold Fast coloured cottons, normally soiled items, shirts, under wear; maximum load 7 kg. - Wash Spin, Rinse Hold, - Rinses Quick Wash, - Long Spin Rinse +, Delay Start Prewash; White cotton (heavy soiled cotton items):e.g. sheets,tablecloths, towels,household linen; maximum load 7 kg.
Control Panel/Before First Use Program; Temperature Type of load; Max. weight of load Cycle description Options can be combined Spin Spin, Delay Start To spin the laundry and to - Drain drain the water in the drum; - Spin phase maximum load 7 kg. Easy Iron; 40° C to Cold Synthetic or mixed fabrics, to be ironed underwear, coloured garments, non-shirnk shirts, blouses; maximum load 3.5 kg. - Wash Spin (Max.
Daily Use 11 5. DAILY USE Connect the mains plug to the mains socket. Turn the water tap on. 5.1 Four Steps Start Up Guide Step 1 - Setting A Program For Washing 4 1 2 1. Turn the program selector dial to the required program. - The selector dial can be turned either clockwise or anticlockwise. - Once you select a wash program, the program selected will stay at that position for the whole of the wash. 2.
Daily Use Step 2 - Loading The Laundry 1. Before loading the laundry, please make sure: Empty pockets. Check and remove objects (if there are any) that could be trapped in the fold. 3. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Tie the cords. 4. Make sure that no laundry remains between the seal and the door. Fasten buttons. Close zippers. Underwired bras must NOT be machine washed. 2. Open the door by carefully pulling the door handle outwards. 5.
Daily Use Step 3 - Using Detergent And Additives 1. Detergent Dispenser Drawer 13 3 Position down : for liquid detergent. Position up : for powder detergent (factory setting). The detergent dispenser is divided into three compartments. Compartment ‘MAIN WASH’ This compartment is used for detergent on all programs. 4 Detergent flap Flap for powder or liquid detergent. Compartment ‘PREWASH’ This compartment is only used for detergent when a Prewash is selected.
Daily Use - If required, pour fabric softener into the compartment marked (the amount used must not exceed the “MAX” mark in the drawer). - Close the drawer gently. Step 4 - Starting a program To start a program, press the Start/Pause ( ) button, the corresponding pilot light will stop flashing and a default program duration will be displayed on the screen. After approx. 15 minutes from the start of a program: 5.2 Interruption Of A Program - To pause press Start/Pause.
Daily Use If the door lock indicator does not disappear, this means that the machine is already heating and the water level is above the bottom edge of the door or the drum is turning. In this case the door CAN NOT be opened. If you can not open the door but you need to open it you have to switch the machine off by turn the program selector knob to the position ‘ ’ to deactivate the appliance. After about 5 minutes the door can be opened. CAUTION! Pay attention to the water level and water temperature. 5.
Washing Hints 6. WASHING HINTS 6.1 Sorting The Laundry Follow the wash code symbols on each garment label and the manufacturer’s washing instructions. Sort the laundry as follows: whites, coloureds, synthetics, delicates, woollens. 6.2 Temperatures For normally soiled white cottons and linen 90°C (e.g. teacloths, towels, tablecloths, sheets...). For normally soiled, colourfast garments (e.g. 60°C shirts, night dresses, 50°C pyjamas....
Washing Hints Rust: oxalic acid dissolved in hot water or a rust removing product used in cold water. Be careful with rust stains which are not recent since the cellulose structure will already have been damaged and the fabric tends to hole. Mould stains: treat with bleach, rinse well (whites and fast coloureds only). Grass: soap lightly and treat with bleach (whites and fast coloureds only). Ball point pen and glue: moisten with acetone (*), lay the garment on a soft cloth and dab the stain.
Washing Hints Any fabric softener or starching additives must be poured into the compartment marked ‘ ’ before starting the wash program. Follow the product manufacturer’s recommendations on quantities to use and do not exceed the MAX mark in the detergent dispenser drawer. Do not spray stain pre-treatment products (e.g. Preen) on or near the machine, as it can attack plastic materials reducing its life. 6.
International Wash Code Symbols 19 7. INTERNATIONAL WASH CODE SYMBOLS These symbols appear on fabric labels, in order to help you choose the best way to treat your laundry. Energetic wash Max. wash Max. wash temperature temperature 95 °C 60 °C Max. wash temperature 40 °C Max. wash temperature 30 °C DO NOT wash at all Hand wash Delicate wash Bleaching Bleach in cold water Ironing Hot iron max. 200 °C Dry cleaning Dry cleaning in all solvents DO NOT bleach Warm iron max.
Care And Cleaning 8. CARE AND CLEANING WARNING! You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. 8.1 External Cleaning Clean the appliance only with soap and warm water. Fully dry all the surfaces. CAUTION! Do not use alcohol, solvents or chemical products. 8.2 Descaling The water we use normally contains lime. It is a good idea to periodically use a water softening powder in the machine.
Care And Cleaning 21 To aid cleaning, the top part of the additive compartment should be removed. 8.6 Cleaning The Drawer Recess Having removed the drawer, use a small brush to clean the recess, ensuring that all washing powder residue is removed from the upper and lower part of the recess. Replace the drawer and run the rinse program without any clothes in the drum. WARNING! Disconnect the mains plug from the mains socket.
Care And Cleaning 2. Open the filter cover by pressing the special hook and by rotating the cover upwards. 4. Hold filter securly and pull upwards to remove it from its position. 5. Clean the filter under the water tap. 3. Remove eliminate the eventual fluff or small objects (if there are any) around the filter. 6. After cleaning the filter, open the filter cover and insert the filter back to its position.
Care And Cleaning 7. IMPORTANT! 23 8. Close the filter cover. The filter is inserted correctly when the indicator on this top is visible and you will hear “Click” sound. 9. Insert the mains plug again. WARNING! Do not start washing clothes without the filter in its place. 8.8 Cleaning The Water Inlet Filter If your water is very hard or contains traces of lime deposit, the water inlet filter may become clogged. 5. Clean the filter in the valve with a stiff brush or a towel.
Care And Cleaning 8.9 The Dangers Of Freezing If the machine is exposed to temperatures below 0°C, certain precautions should be taken. Do this procedure also when you want to do the emergency drain. Disconnect the mains plug from the mains socket. 1. Turn off the water tap. 2. Unscrew the inlet hose. 3. Remove the drain hose from the rear support and unhook it from sink or spigot. 4. Put the ends of the drain and inlet hose in a container. Let the water flow out of the hoses. 5.
Troubleshooting 25 9. TROUBLESHOOTING Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Service Centre, please carry out the checks listed below. During machine operation it is possible that the red Start/Pause pilot light flashes to indicate that the machine is not working. Once the problem has been eliminated, press the Start/Pause button to restart the program.
Troubleshooting Malfunction There is water on the floor: Unsatisfactory washing results: The door will not open: The machine vibrates or is noisy: Cycle time longer than displayed: Possible cause Solution Too much detergent or unsuitable detergent (creates too much foam) has been used. Reduce the detergent quantity or use another one. Check whether there are any leaks from one of the inlet hose fittings.
Troubleshooting Malfunction Possible cause The electronic unbalance detection device has cut in because the laundry is not evenly distributed in the drum. Spinning starts late or the machine does not spin: The machine makes an unusual noise: No water is visible in the drum: 27 Solution Pause the machine and redistribute laundry manually. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume.
Technical Data 10. TECHNICAL DATA Dimensions Width 60 cm Height 85 cm Depth 56 cm Power supply (voltage/frequency) 220-240 V/50 Hz Total power absorbed 2000 W Minimum fuse protection Water supply pressure Maximum load Spin speed 10 A Maximum 0.8 MPa Minimum 0.05 MPa Programs Max. Load Cottons 7.0 kg Prewash 7.0 kg Cottons Eco 7.0 kg Synthetics 3.5 kg Cold 2.5 kg Delicates 3.5 kg Wool 2.0 kg Rinse 7.0 kg Drain 7.0 kg Spin 7.0 kg Easy Iron 3.5 kg Blanket 3.
Installation 29 11 .INSTALLATION 11.1 Unpacking CAUTION! All transit bolts and packing must be removed before using the appliance. You are advised to keep all transit devices so that they can be refitted if the machine ever has to be transported again. 1. Use gloves. Remove the external film. If necessary, use a cutter. 6. Put one of the polystyrene packaging elements on the floor behind the appliance. Carefully put down the appliance with the rear side on it. Make sure not to damage the hoses. 2.
Installation 11.2 Positioning A 10. Remove the three bolts. 11. Pull out the plastic spacers. It is important that your washing machine stands firm and level on the floor to ensure correct operation. That the appliance must not be installed behind a lockable door, a sliding door or a door with a hinge on the opposite side to that of the washing machine door is restricted. Use a spirit level on the top and side of the washing machine to check the levels. 12. Put the plastic caps in the holes.
Installation 31 When the washing machine is levelled, try to rock it from corner to corner. If it does rock, adjust the legs again until it is levelled and does not rock. The inlet hose must not be lengthened. If it is too short and you do not wish to move the tap, you will have to purchase a new, longer hose specially designed for this type of use. Never place cardboard, wood or similar materials under the machine to compensate for any unevenness in the floor. Install the machine on a flat hard floor.
Installation The end of the drain hose must always be ventilated, i.e. the inside diameter of the drain pipe must be larger than the outside diameter of the drain hose. 60 cm The drain hose must not be kinked. Run it along the floor; only the part near the drainage point must be raised. 90 cm 32 For the correct functioning of the machine the drain hose must remain hooked on the proper support piece situated on the top part of back side of the appliance. 11.
Environment Concerns 33 12. ENVIRONMENT CONCERNS 12.1 Packaging Materials The materials marked with the symbol are recyclable. >PE<=polyethylene >PS<=polystyrene >PP<=polypropylene This means that they can be recycled by disposing of them properly in appropriate collection containers. 12.2 Old Machine Use authorised disposal sites for your old appliance. Help to keep your country tidy! The symbol on the product or on its packaging indicates that this product may not be treated as household waste.
NOTE
www.simpson.com.
