SDS
SET
®
Anchoring Adhesive
SAFETY DATA SHEET
SET
®
Page 5 of 10
Additional Information
After Cure: After Cure: Product forms an innocuous solid. Processing after cure (grinding or cutting) may
produce dust containing compounds that present an inhalation hazard.
9. Physical and Chemical Properties
Property
Resin
Hardener
Physical State:
Liquid, Paste
Liquid, Paste
Color:
White
Black
Odor:
Sweet
Ammonia
pH:
6.9
10.6
Flammability limit – lower %:
Flammability limit – upper %:
No data
No data
No data
No data
Vapor Pressure:
Non-volatile
No data
Vapor Density:
No data
No data
Solubility:
Insoluble in water
Slightly soluble in water
Freezing/Melting Point:
No data
No data
Boiling Point:
> 500 °F (>260 °C)
No data
Flash Point:
250 °F (121 °C) Open Cup
198 °F (92.2 °C) Open Cup
Evaporation Rate:
No data
No data
Decomposition Temperature:
No data
No data
Specific Gravity:
1.21 at 72°F (22°C)
1.23 at 72°F (22°C)
VOC (after cure):
6 g/L
6 g/L
Kow:
No data
No data
Viscosity:
No data
No data
10. Stability and Reactivity
Resin (white side)
Reactivity: This product is stable and non-reactive under normal conditions.
Chemical Stability: Stable under normal storage conditions.
Condition to Avoid: High heat and open flame.
Substances to Avoid: Oxidizing agents, acids, organic bases, and amines.
Hazardous Reactions: Hazardous polymerization does not occur.
Decomposition Products: Carbon dioxide, carbon monoxide, oxides of nitrogen, and other organic compounds.
Hardener (black side)
Reactivity: This product is stable and non-reactive under normal conditions.
Chemical Stability: Stable under normal storage conditions.
Condition to Avoid: High heat and open flame.
Substances to Avoid: Strong oxidizing agents. Strong acids.
Hazardous Reactions: Hazardous polymerization does not occur.
Decomposition Products: Carbon dioxide, carbon monoxide, oxides of nitrogen, and other organic compounds.
Component
*Skin Designation
OSHA
(PEL)
ACGIH
(TLV)
NIOSH
Pocket Guide
Benzyl Alcohol
(CAS 100-51-6)
N/E
N/E
44.2 mg/m
3
10 ppm
Furfuryl alcohol *
(CAS 98-00-0)
N/E
15 ppm (STEL)
10 ppm (TWA)
40 mg/m
3
10 ppm
N-Butyl Glycidyl Ether
(2426-08-6)
270 mg/m
3
50 ppm
3 ppm
30 mg/m
3
(Ceiling)
5.6 ppm (Ceiling)
Titanium Dioxide
(13463-67-7)
5 mg/m
3
(respirable)
15 mg/m
3
(total dust)
10 mg/m
3
N/E