MSDS
S
ET
Epoxy
-
Tie
®
Anchoring Adhesive
-
MATERIAL SAFETY DATA SHEET
PAGE
5
OF
6
Form T
-
SAS
-
SET
MSD09
V.
FIRE
-
FIGHTING MEASURE
S
Suitable Extinguishing Media
:
Water
spray,
fog
or foam, carbon dioxide, dry chemical, limestone powder.
Fire And Explosion Hazard:
Irritating and toxic fumes m
ay be
produced at high temperature. In a fire, may produce
carbon monoxide
,
toxic
nitrogen oxide, ammonia, and carbon dioxide
.
Use of water may
result in the formation of very toxic aqueous solution.
Do not allow run
-
off from fire
fighting to enter
drains or
water courses.
Fire Fighting Equipment
and
Wear full protective clothing and
self
-
contained breathing apparatus
for fire fighting.
Procedures:
Isolate fuel supply from fire. Clear fire area of all non
-
emergency personnel.
VI
.
ACCIDE
NTAL RELEASE MEASURES
Personal Precautions:
Use cautious judgment when cleaning up spill. Shut off leaks, if possible without
personal risk. Wear suitable protective clothing, gloves and eye/face protection.
Evacuate personnel to safe areas.
Envir
onmental Precautions:
Construct a dike to prevent spreading.
Keep out of sewers, storm drains, surface waters,
and soils.
Clean
-
up Methods:
Small spills
: Soak up with
absorbent material such as clay, sand or other
suitable non
-
reactive
material
. Place in l
eak
-
proof
containers. Seal tightly
for
proper disposal.
Large spills
:
Approach suspected leak areas with caution. Create a d
ike
or trench to
contain material.
Soak up with
absorbent material such as clay, sand or other
suitable
non
-
reactive
material. Place in l
eak
-
proof
containers. Seal tightly
for
proper disposal.
Additional
Information:
Notify
authorities if any exposures to the general public or environment occur or are
likely to occur. Dispose
in accordance with federa
l, s
tate, and local regulations.
VI
I.
STORAGE AND HANDLING
Storage:
Keep away from: acids, oxidizers, heat, or flames. Keep in cool, dry, well
-
ventilated area
in closed containers. Protect
containers from physical damage.
Handling:
To prevent s
kin and eye
contact under the foreseeable conditions of use, wear
appropriate protective clothing and safety eyewear. When handling, do not eat, drink, or
smoke. Wash thoroughly after handling. Avoid breathing fumes. Handle
in a well
venti
lated work area.
VIII.
EXPOSURE
CONTROLS / PERSONAL PROTECTION
Protective Measure:
Wear appropriate personal protective equipment.
Eye Protection:
Avoid
contact with eyes. Wear chemical splash goggles or safety glasses with side
shield.
Hand Protection:
Wear chemical
-
resistant gloves such as: Nitrile, neoprene, butyl.
Skin and Body Protection:
Wear chemical
-
resistant gloves and other clothing as required to minimize contact.
Respirator Protection:
Not required for properly ventilated areas.
Exposure
Limits:
Chemical Names
ACGIH
(TLV)
OSHA
(PEL)
N-
aminoethylpiperazine
N/E N/E
Nonylphenol
N/E N/E
Phenol, 4,4
-
(1
-
methylethylidene)bis
N/E N/E
Silica, crystalline quartz (airborne
particulates of respirable size)
0.1mg/m
3
0.4mg/m
3
IX.
PHYSICAL PROPERTIES
Form
:
P
aste
Color
:
Black
Odor:
Ammonia
Boiling Point
:
N/E
Freezing Point:
N/E
Vapor Pressure
:
N/E
Flash Point:
198ºF (Open
cup
)