SDS

ManualsBrandsSimpson Strong-Tie ManualsPaintEpoxy-Tie 22 oz. Cartridge

SET-XP

High Strength Anchoring Adhesive for Cracked and Uncracked Concrete

SAFETY DATA SHEET

SET-XP

Page 1 of 9

1. Identification

Product Identification

Product Identifier: SET-XP (SET-XP10, SET-XP22, SET-XP56, SET-XP650, SET-XP)

Recommended Use: High Strength Anchoring Adhesive for Cracked and Uncracked Concrete

Use Restrictions: None Known.

Company Identification

Company: Simpson Strong-Tie Company Inc.

Address: 5956 W. Las Positas Blvd.

Pleasanton, CA 94588

Phone: 1-800-999-5099

Website: www.strongtie.com

Emergency: 1-800-535-5053 (US/Canada) / 1-352-323-3500 (International)

For most current SDS, please visit our website at www.strongtie.com/sds

2. Hazard Identification

General Information

SET-XP Anchoring Adhesive is a two part system. The two parts of this product have been assessed according to GHS and are classified

below. The final hardened material is considered nonhazardous. Some hazards apply upon grinding or cutting through hardened product.

Resin (white side) GHS Classification

Physical Hazards: Not Classified.

Health Hazards: Skin Corrosion/Irritation Category 2

Serious Eye Damage/Irritation Category 2A

Sensitization, Skin Category 1

Germ Cell Mutagenicity Category 2

Environmental Hazards: Chronic Aquatic Environmental Hazard Category 2

Signal Word: WARNING!

Hazard Statements: Causes skin irritation. Causes serious eye irritation. May cause an allergic skin reaction. Suspected

of causing genetic defects. Toxic to aquatic life with long lasting effects.

Precautionary Statements:

Prevention: Obtain special instructions before use. Do not handle until all safety precautions have been read

and understood. Wear protective gloves/protective clothing/eye protection/face protection.

Contaminated work clothing should not be allowed out of the workplace. Avoid breathing mist or

vapor. Wash thoroughly after handling. Avoid release to the environment.

Response: If exposed or concerned: Call a poison center/doctor. If on skin: Wash with plenty of water. If skin

irritation or rash occurs: Get medical advice/attention. Take off contaminated clothing and wash

before re-use. If in eyes: Rinse cautiously with water for several minutes. Remove contact lenses, if

present and easy to do. Continue rinsing. If eye irritation persists: Get medical advice/attention.

Collect Spillage.

Storage: Store locked up. Store in a well-ventilated place. Store between 45-90°F (7-32°C).

Disposal: Dispose of contents/container in accordance with local/regional/national regulations.

Hardener (green side) GHS Classification

Physical Hazards: Not Classified.

Health Hazards: Skin Corrosion/Irritation Category 1

Serious Eye Damage/Irritation Category 1

Sensitization, Skin Category 1

Summary of content (18 pages)

PAGE 1
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET 1. Identification Product Identification Product Identifier: Recommended Use: Use Restrictions: Company Identification Company: Address: SET-XP (SET-XP10, SET-XP22, SET-XP56, SET-XP650, SET-XP) High Strength Anchoring Adhesive for Cracked and Uncracked Concrete None Known. Simpson Strong-Tie Company Inc. 5956 W. Las Positas Blvd. Pleasanton, CA 94588 Phone: 1-800-999-5099 Website: www.strongtie.
PAGE 2
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET Environmental Hazards: Signal Word: Hazard Statements: Precautionary Statements: Prevention: Response: Storage: Disposal: Germ Cell Mutagenicity Acute Aquatic Environmental Hazard Chronic Aquatic Environmental Hazard Category 2 Category 3 Category 3 DANGER! Causes severe skin burns and eye damage. May cause an allergic skin reaction. Suspected of causing genetic defects.
PAGE 3
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET 4. First-Aid Measures General Information Provide general supportive measures and treat symptomatically. Symptoms may be delayed. Ensure that medical personnel are aware of the material(s) involved, and take precautions to protect themselves. If exposed or concerned: Get medical advice/attention. Wash contaminated clothing before reuse.
PAGE 4
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET 8. Exposure Controls / Personal Protection Personal Protective Equipment Protective Measure: Eye Protection: Hand Protection: Skin and Body Protection: Respirator Protection: General Hygiene: Wear appropriate personal protective equipment. Wear chemical splash goggles or safety glasses with side shield. Wear chemical-resistant gloves such as: Nitrile, neoprene, butyl.
PAGE 5
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET 10. Stability and Reactivity Resin (white side) Reactivity: Chemical Stability: Condition to Avoid: Substances to Avoid: Hazardous Reactions: Decomposition Products: Hardener (green side) Reactivity: Chemical Stability: Condition to Avoid: Substances to Avoid: Hazardous Reactions: Decomposition Products: 11. This product is stable and non-reactive under normal conditions. Stable under normal storage conditions.
PAGE 6
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET 12. Ecological Information General Information Information given is based on data on the components and the ecotoxicology of similar products. Resin is classified as toxic to aquatic life with long lasting effects. Hardener is classified as harmful to aquatic life with long lasting effects. Avoid release to the environment.
PAGE 7
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code: This substance/mixture is not intended to be transported in bulk This information does not cover all specific regulatory or operational requirements of this product. The classifications for transportation may vary by container volume or different regional or national regulations. 15.
PAGE 8
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET WHMIS Classification Class D-2A: Material Causing other toxic effects Class E: Corrosive International International Inventories Country or Region Australia Canada United States & Puerto Rico 16.
PAGE 9
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET CPR: DOT: EPA: GHS: HEPA: HMIS: IARC: IATA: IMDG: LPP: NIOSH: NFPA: NTP: OSHA: PEL: SARA: SDS: STEL: STOT: TLV: TSCA: TWA: U.S.: VOC: WHMIS: Controlled Product Regulations (Canada) Department of Transportation (U.S.) Environmental Protection Agency (U.S.
PAGE 10
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET 1. Identification Product Identification Product Identifier: Recommended Use: Use Restrictions: Company Identification Company: Address: SET-XP (SET-XP10, SET-XP22, SET-XP56, SET-XP650, SET-XP) High Strength Anchoring Adhesive for Cracked and Uncracked Concrete None Known. Simpson Strong-Tie Company Inc. 5956 W. Las Positas Blvd. Pleasanton, CA 94588 Phone: 1-800-999-5099 Website: www.strongtie.
PAGE 11
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET Environmental Hazards: Signal Word: Hazard Statements: Precautionary Statements: Prevention: Response: Storage: Disposal: Germ Cell Mutagenicity Acute Aquatic Environmental Hazard Chronic Aquatic Environmental Hazard Category 2 Category 3 Category 3 DANGER! Causes severe skin burns and eye damage. May cause an allergic skin reaction. Suspected of causing genetic defects.
PAGE 12
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET 4. First-Aid Measures General Information Provide general supportive measures and treat symptomatically. Symptoms may be delayed. Ensure that medical personnel are aware of the material(s) involved, and take precautions to protect themselves. If exposed or concerned: Get medical advice/attention. Wash contaminated clothing before reuse.
PAGE 13
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET 8. Exposure Controls / Personal Protection Personal Protective Equipment Protective Measure: Eye Protection: Hand Protection: Skin and Body Protection: Respirator Protection: General Hygiene: Wear appropriate personal protective equipment. Wear chemical splash goggles or safety glasses with side shield. Wear chemical-resistant gloves such as: Nitrile, neoprene, butyl.
PAGE 14
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET 10. Stability and Reactivity Resin (white side) Reactivity: Chemical Stability: Condition to Avoid: Substances to Avoid: Hazardous Reactions: Decomposition Products: Hardener (green side) Reactivity: Chemical Stability: Condition to Avoid: Substances to Avoid: Hazardous Reactions: Decomposition Products: 11. This product is stable and non-reactive under normal conditions. Stable under normal storage conditions.
PAGE 15
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET 12. Ecological Information General Information Information given is based on data on the components and the ecotoxicology of similar products. Resin is classified as toxic to aquatic life with long lasting effects. Hardener is classified as harmful to aquatic life with long lasting effects. Avoid release to the environment.
PAGE 16
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code: This substance/mixture is not intended to be transported in bulk This information does not cover all specific regulatory or operational requirements of this product. The classifications for transportation may vary by container volume or different regional or national regulations. 15.
PAGE 17
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET WHMIS Classification Class D-2A: Material Causing other toxic effects Class E: Corrosive International International Inventories Country or Region Australia Canada United States & Puerto Rico 16.
PAGE 18
SET-XP® High Strength Anchoring Adhesive for Cracked and Uncracked Concrete SAFETY DATA SHEET CPR: DOT: EPA: GHS: HEPA: HMIS: IARC: IATA: IMDG: LPP: NIOSH: NFPA: NTP: OSHA: PEL: SARA: SDS: STEL: STOT: TLV: TSCA: TWA: U.S.: VOC: WHMIS: Controlled Product Regulations (Canada) Department of Transportation (U.S.) Environmental Protection Agency (U.S.