Installation Guide

To operate the LED lights, press the rocker switch located on the crank housing on or off.
NOTE:
a) The Finial (D) contains two lithium batteries (2 x 2200mAh). Press the switch to the off position during daylight
to allow the solar panel to charge the batteries. Charging time is dependent on the amount of sunlight, however, 8
hours is recommended.
b) The batteries can also be charged using the 100V~240V AC Adapter (E) by plugging it into the crank housing
as shown in the illustration. Charging time is approximately 5 - 6 hours.
c) If the batteries are dead, the lights will operate with the AC Adapter (E) plugged in. The red light on the AC
Adapter (E) indicates power is present.
d) Keep the umbrella unplugged and the AC Adapter (E) stored in a dry location when not in use.
5
On/Off Switch
100V~240V AC
E
5
OPERATION OVERVIEW
D