Instructions / Assembly
14
VERTICAL PANELS AND BASEBOARD MOLDING
To accommodate your baseboard molding, you
cam shelves.
Floor-Based Vertical Panel
Note: We recommend that you remove your
units. After installing your system, reinstall
pieces of the molding in any areas not
covered by the units.
Cam shelf
Toe kick
Cut panel and shelf
for base molding.
The following instructions apply to 84
units, hutch units and mid-height 30" storage units.
Tip: Before beginning, lay cardboard or other protection
of your units.
1. Install cam screws in top holes of vertical panels, taking
care to use single or double cam screws as called for.
2. Install cam screws for lower/bottom cam shelves
according to your design. Follow cam shelf instructions
from previous page.
3. Connect cam shelves to a pair of vertical panels, with
the parts standing on their back edge.
Note: Install the bottom cam shelf in the 3rd hole from the
bottom of the vertical panel.
4. Carefully tip unit into an upright position and move into
place.
5. Add remaining cam shelves and vertical panels, if the
unit has more than one section.
Tip: Bottom cam shelves can be installed
while the shelf is tilted up like a theater
seat. You may need to pull the unit away
from the wall slightly to avoid scraping
the wall as you lower the front of the
shelf. A stubby or offset screwdriver is
6. Using a level, shim vertical panels, if necessary, to
ensure the top is straight and level.
FLOOR-BASED SYSTEM INSTALLATION