Instructions / Assembly

19
INSTALLING ADD-ONS
ATTACH FULL-EXTENSION GLIDES
TO VERTICAL PANELS
Drawer locations are determined by your design. Follow the guidelines in the nearby
illustration to install the cabinet section of the glides, beginning with the glides for
the bottom drawer.
1. Glides for the bottom drawer are installed in the 2nd open hole above the cam shelf.
2. Glides for 12" drawers have 8 open holes above before the next set of glides.
3. Glides for 8" drawers have 5 open holes above before the next set of glides.
4. Glides for 5" drawers have 3 open holes above before the next set of glides.
5. Cam shelf above top drawer is installed one hole lower than if it were another
set of glides.
Space for
5" drawer
Space for
5" drawer
Space for
8" drawer
Space for
12" drawer
Front of
vertical panel
Attach drawer glide
cabinet panel sections
to vertical panels using
Euro screws.
3 open holes
8 open holes
5 open holes
Drawer boxes and drawer fronts are packed separately.
Drawer pulls, glides and screws are found in your

have a separate box of glides.
ASSEMBLE DRAWER WITH
FULL-EXTENSION GLIDES
NOTE: The glides consist of drawer box sections and
unit panel sections. Separate them by sliding the
plastic lever and pulling apart.
1. Separate the drawer box section by holding the black
 
2. Locate and align. Align the closed end of the drawer
 
drawer box. The side of the drawer box includes
dimples to help you align the glide location top to
bottom. When the glide is in the proper installation
location, the dimples will be visible through the holes
in the glide.
3. 
5/8" screws on each side. Install a screw through the
glide hole and into the dimple closest to the front of
 
 
near the middle of the box last.
4. Drill for the knob using a 5mm or 3/16" drill bit
through the countersunk hole located on the back
side of the drawer front. Using screw paired with the
knob, attach to drawer front tightly though holes.
5. SHAKER method for attaching drawer fronts. Pound
 
 
 
screwdriver only.
6. STANDARD method for attaching drawer fronts.
 
to box. Do not fully tighten. Use hand screwdriver only.
1b
1a
Drawer box
section
Unit panel
section
PULL
FORWARD
PUSH
LEVER
2
3
4
5a
5b
6