Installation Guide

ASSEMBLY INSTRUCTIONS

7. Line up the two holes in the bottom of the Umbrella

(A) pole with the Rotating Hub (C) and slide the

Umbrella (A) pole down over the Rotating Hub (C) .

Using the Large Wrench (AA), secure the Umbrella

(A) pole to the Rotating Hub (C) with 2pcs Bolts (CC)

and 2pcs Washers (DD) .

CAUTION: When cranking the umbrella open, if you

feel resistance and the canopy is not opening, do not

force the crank handle. Gently spread the umbrella

ribs by hand and shake the fabric, then continue to

crank open.

OPERATING INSTRUCTIONS

8. With the umbrella in an upright position, unfasten the

Storage Tie from around the canopy. Gently spread the

umbrella ribs and fabric by hand to free up parts that

may have become wedged during shipping.

To prevent undue stress on the cranking system, do not

attempt to crank open the umbrella from the lowest

position. (1) Open the umbrella canopy by first gripping

the lever on the vertical slide handle and slowly raise to

a convenient height. Release the slide handle to lock

into place. (2) Slowly turn the Crank Handle (EE) in a

clockwise direction until the canopy is fully opened.

x 1

x 2

Large Wrench

Bolt

Washer

x 2

Storage Tie

9. With the canopy fully opened, grip the lever on the

vertical slide handle and raise or lower the canopy to

desired angle. Release the slide handle to lock into

place. To close the umbrella, turn the Crank Handle

(EE) counter-clockwise .