Installation Guide

x 1

Small Wrench

Crank Handle

x 1

ASSEMBLY INSTRUCTIONS

4. Assemble the Plastic Base (E) by interlocking the

4pcs together onto the Metal Stand (D).

You may need to reposition the pedal on the Rotating

Hub (C) in this step. To do this, press down on the

pedal and rotate either direction to reach desired

position.

5. To install the Solar Panel (B), remove the Pole

Cap (GG) on top of the umbrella pole by turning in a

counter-clockwise direction . Insert the tabs on the

bottom of the Solar Panel (B) into the slots on the top

of the umbrella pole and twist in a clockwise direction

approximately 1/4 turn until it is secure.

Save the Pole Cap (GG) for future use. To extend the

life of the Solar Panel (B), it is recommended to

remove the solar panel and replace the pole cap thru

the winter or during extended periods when the

umbrella is not in use.

6. Fit the Crank Handle (EE) over the crank

mechanism. Secure the Crank Handle (EE) onto the

crank mechanism using the Small Wrench (BB) to

tighten the setscrew.

iii