Installation Guide

©2017 Knape & Vogt. All rights reserved. Knape & Vogt
®
reserves the right to change specifications without notice. 310582/0917
Grand Rapids, MI
800.253.1561
simplyputorganizers.com
WIDE INSTALLATION
USES 1
ST
AND 3
RD
HOLE BACK
NARROW INSTALLATION
USES 2
ND
AND 4
TH
HOLE BACK
WIDE
INSTALLATION
NARROW
INSTALLATION
Single Pullout Waste Bin
Installation Instructions
Inspect all parts and read all instructions prior to beginning assembly and installation.
SP-ECW10-1-35-W
Place installation template on cabinet
floor. Drill 4 holes at locations shown on
template with 1/16" drill bit. Once the
position is determined, fasten the sliding
base assemblies to the cabinet floor by
using 2 – #8 x 1/2" mounting screws for each
slide assembly shown in image 1 below.
Tighten with a Phillips head screwdriver.
Fully extend slides out of cabinet and then
install 1/ea cage mounting clip bottom onto
each slide by fastening with 2 – #6 x 3/8"
cage mounting screws as shown in images
2a and 2b.
Place wire cage on top of the cage mounting
clip bottoms as shown in image 3 below.
Then install each cage mounting clip tops
with 2 – #6 x 3/4" cage clip screws as
shown in image 4.
With slides fully extended insert the bin
into the cage.
1
Tools Required
• Phillips Head Screwdriver
• Drill with 1/16" (1.5mm) bit for
drilling pilot holes
• Pencil
Product Assemblies
Waste Bin (1)
Wire Cage (1)
Cage Mounting Clips (2)
Slide Assemblies (2)
#6 x 3/8 Large
Mounting Screws
#8 x 1/2" Mounting
Screws for Slide
Assemblies (4)
6 x 3/4" Cage Clip
Screws (4)
Installation Template
(not shown)
Parts Included
1
2a
2b
3 4
2
3
4