Installation Guide

Grand Rapids, MI
800.253.1561
simplyputorganizers.com
©2018 Knape & Vogt. All rights reserved. Knape & Vogt
®
reserves the right to change specifications without notice. 310577/1218
Push the slide back so that the
mounting hole is accessible.
Install 1 – #6 x 1/2" wood
screw (4).
Ensure that upright brackets
are parallel to the front of the
cabinet then attach to the base
of the cabinet with 4 – #8 x 3/4"
wood screws (5A).
NOTE: Screws can be placed
in slotted holes for future
adjustment or in round holes to
ensure the unit does not move.
Push rear slide brackets back
until they are against the back
of the cabinet. Attach to the
back of the cabinet with 3 –
#6 x 1/2" wood screws
per bracket (5B).
Fully extend slides. Install lower
basket to left hand slide by
inserting tabs through the slots
on the wire basket. Next push
basket down into hooks on right
hand slides while supporting the
slide member. Repeat process
for upper basket (6).
NOTE: Install smaller basket on
bottom and larger basket on top.
Using 1-#6-32x5/16" screw
install cross-brace to left-hand
side of front upright bracket
directly below upper basket
slides. Repeat process for
right –hand side of front
upright bracket.
4
5A
5B
6
Left Slide Right Slide
6
5
4
5B
5A
7
7