Operating Guide

Grand Rapids, MI
800.253.1561
simplyputorganizers.com
©2017 Knape & Vogt. All rights reserved. Knape & Vogt
®
reserves the right to change specifications without notice. 310577/1017
Push the slide back so that the
mounting hole is accessible.
Install 1 – #6 x 1/2" wood
screw (4).
Ensure that upright brackets
are parallel to the front of the
cabinet then attach to the base
of the cabinet with 4 – #8 x 3/4"
wood screws (5A).
NOTE: Screws can be placed
in slotted holes for future
adjustment or in round holes to
ensure the unit does not move.
Push rear slide brackets back
until they are against the back
of the cabinet. Attach to the
back of the cabinet with 3 –
#6 x 1/2" wood screws
per bracket (5B).
Fully extend slides. Install lower
basket to left hand slides by
placing tabs through the wire
basket. Next push basket into
hooks on right hand slides
while supporting the slide
member. Repeat process for
upper basket (6).
Using 1-#6-32x5/16" screw
install cross-brace to left-hand
side of front upright bracket
directly below upper basket
slides. Repeat process for
right –hand side of front
upright bracket.
4
5
6
7
Left Slide Right Slide
6
5
4
5B
5A
8
8