User guide

ManualsBrandsSimply Automated ManualsHealth and hygieneUPP

Model UCS-01

Using the UCS, Controller Scheduler-Timer

The Scheduler-Timer is designed for accuracy and maximum flexibility. Once the

UCS is set for time, date, day of the week, location and Network ID, then all that

is needed is setting each event for the desired ON and OFF time. Upon

completion of configuring the Scheduler-Timer, switching from ON [RUN] to

vacation [VAC] mode should be all that is needed for years of reliable use.

Simply Automated, Incorporated

5825 Avenida Encinas, Suite 101, Carlsbad, CA 92008 USA

Technical Support: www.simply-automated.com or 800-630-9234

452-0031-0101 Rev A Revised: June 22, 2006

Controller, Scheduler-Timer

Model UCS-01

User Guide

Summary of content (6 pages)

PAGE 1
Model UCS-01 Using the UCS, Controller Scheduler-Timer The Scheduler-Timer is designed for accuracy and maximum flexibility. Once the UCS is set for time, date, day of the week, location and Network ID, then all that is needed is setting each event for the desired ON and OFF time. Upon completion of configuring the Scheduler-Timer, switching from ON [RUN] to vacation [VAC] mode should be all that is needed for years of reliable use.
PAGE 2
Model UCS-01 Controller, Scheduler-Timer CIM Mode To configure the Scheduler-Timer to operate as a Computer Interface Module (CIM), allowing a PC with Upstart to access a UPB network, select the CIM mode from the menu and press ENTER button to initiate CIM mode operation. Note the unit will not run scheduled events when in the CIM mode. During CIM mode operation pressing any button will end the CIM mode function. There is no timeout period for CIM mode.
PAGE 3
Model UCS-01 Controller, Scheduler-Timer OTHER MENU SELECTIONS DESCRIPTION Delete Events The UPB Controller, Scheduler-Timer (model UCS) provides control of UPB devices or UPB Links according to a user defined event or schedule. It is designed to communicate with a UPB network when connected to a standard power receptacle; using the L-shaped power connector or the 6 foot power cord, both included.
PAGE 4
Model UCS-01 INSTALLATION The Scheduler-Timer is designed for indoor use. Simply plug the appropriate end of the power cord or L-shaped connector into the top of the UCS, and the other end into any 120-volt outlet. For convenience the L-shaped power connector is designed to hang the unit from a high (mid-wall) receptacle, typically found in the kitchen or garage. The 6 foot power cord can be used when programming as a hand-held device, or when mounting the unit in some other location (e.g. table top).
PAGE 5
Model UCS-01 Controller, Scheduler-Timer Step D: Set Events Hint: Each Event in the FUNCTION / NAVIGATION Scheduler-Timer requires the Device ID of the UPB device or the Link ID of the UPB Link to be controlled. It is highly recommended that the user creates a list of Device ID and Link ID numbers correlating to the UPB devices to be controlled before setting up the events. This will prove useful when entering events since the list can be quickly referenced to tie the UPB device to the event.
PAGE 6
Model UCS-01 Controller, Scheduler-Timer Step B: Set Location INITIAL CONFIGURATION NOTE: In order to completely configure the Scheduler-Timer it is necessary to know the Network ID, Device ID(s) and Link ID(s) to be controlled, writing down the Device ID for each UPB device to be scheduled is recommended. • • Press MENU from the Idle Screen. Press the Down button to select Set Location. • Press ENTER button to view the Set Location sub-menu. • Select Zip Code and press Enter .