Installation Manual: 22.8kWh

SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93030, USA | [phone] | [e-mail] | SimpliPhiPower.com
| 44 |
7. While the PHI Battery does not require an Equalization charge, programming Equalization to the voltage, frequency
and duration outlined in the table above ensures that the Sol-Ark’s internal SoC meter re-sets to 100% SoC every 30
days.
8. Smart Loads are no longer powered via solar and/or batteries when the batteries’ SoC level drops below this
programmed Smart Load OFF Batt value.
9. Smart Loads are powered via solar and/or batteries when the batteries’ SoC level exceeds this programmed Smart
Load ON Batt value.
10. The Sol-Ark stops charging the batteries and powering the loads from the AC Coupled solar PV array once the
batteries’ SoC level reaches the Smart Load OFF Batt value.
11. The Sol-Ark triggers the AC Coupled solar PV array to produce power (powering the loads and charging the
batteries) when the batteries’ SoC level exceeds this programmed Smart Load ON Batt value.
CAUTION: When PHI battery quantities change, the capacity & charge/discharge current settings
must be reassessed. Failure to do so will Void the Warranty. Modification to original factory settings
can only be accessed by using installer password.
REV20210319