Installation

REV073019

| 27 |

Figure 15.0 – Inverter Charge Rate Display

This completes the functional test. The internal set points have been pre-programmed for the PHI

3.8 Battery bank.

4.6 – AccESS Optional Components/Accessories Installation

4.6.1 – DC Coupled PV – 4.8 kW

The AccESS may be DC Coupled with a PV system up to 4.8 kW DC. Please refer to Schneider

Electric’s MPPT 80 600 installation manual and wiring diagrams for further information.

4.6.2 – Remote System Monitoring

Schneider Electric Conext ComBox

If purchased with the Conext Gateway or ComBox option, please refer to the Conext Gateway or

ComBox Owner’s Guide from Schneider Electric.

Network Requirements

Before making AC and DC connections, route communication cables through the raceways. For

easier identification, use a different color for each communications cable, or cable tags.

Connect communications cables to their components after AC and DC connections are made.

4.6.3 – Automatic Generator Start

Schneider Electric Conext AGS

If purchased with the Conext Automatic Generator Start, please refer to the Conext Automatic

Generator Start Owner’s Guide from Schneider Electric.

4.6.4 – Battery Monitoring

Schneider Electric Conext Battery Monitor

If purchased with the Conext ComBox, the Conext Battery Monitor is included on the exterior

door. This comes pre-wired and configured, but for more information, see the Conext Battery

Monitor Quick Start Guide.