Installation

REV073019
SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93030, USA | [phone] | [e-mail] | SimpliPhiPower.com
| 24 |
Figure 10.0 – Inverter Power-Up Standby Display
Step 3: Enable the Inverter
Invert mode is enabled by default, and the Conext XW Pro or XW+ should begin inverting upon
transitioning from standby mode. If invert mode is disabled, the inverter information panel will
display "- - -" once out of standby mode, as shown below. If the Conext XW Pro or XW+ powers
up in standby mode, press the STARTUP/ SHUTDOWN button momentarily to change the mode
from standby to operating.
Figure 11.0 – Inverter Disabled Display
To enable the inverter:
On the inverter information panel, simultaneously press the STARTUP/ SHUTDOWN button and
the Equalize button. The Conext XW Pro or XW+ is now enabled, and “En” (enabled) is briefly
displayed on the inverter information panel