A-4PHI-OB Installation

REV0720

| 15 |

For FM80 MPPT Wiring information please refer to OutBack FM80 installation manual

http://www.OutBackpower.com/downloads/documents/charge_controllers/flexmax_6080/owner_manual.p

5.0 – Programming

5.1 – Depth of Discharge

The AccESS comes pre-programmed for 80% depth of discharge (DoD). This qualifies for the 10-year /

10,000 cycle Warranty on the PHI 3.5 Batteries.

To change the DoD to the 5,000 cycle Warranty or 3,500 cycle Warranty, modify the voltages in the Basic

Settings and Advanced Settings per the Programming section. Refer to the PHI 3.5 Battery Warranty.

If a firmware update is executed on the AccESS, please verify all PHI custom settings are still in place.

These settings can be found at the end of this manual in Section 7.0: Operating Parameters.

5.2 – Configuring the OutBack Radian GS8048

The OutBack Radian is capable of many different modes of operation via configurable settings. These

settings can be modified to support the function the owner would like to achieve with the AccESS unit. To

configure the AccESS, please refer to OutBack Radian GS8048 manual.

The OutBack Owner’s Guide contains information and procedures necessary for configuring, operating,

maintaining, and troubleshooting the OutBack Radian Inverter/Charger. The guide is intended for anyone

who needs to operate, configure, and troubleshoot the inverter. Certain configuration tasks should only be

performed by qualified personnel.

5.3 – Operating Parameters Per Warranty

Although the PHI 3.5 Batteries within the AccESS unit are capable of performing at very high rates and

depths of discharge within a very wide temperature range, in order to achieve extended life cycles and to

comply with the Warranty, the operating parameters, indicated in the tables below, must be adhered to.

The parameters shown must be applied based on desired Warranty/cycle life. The AccESS comes pre-

programmed for 80% depth of discharge.