Installation

REV073019
SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93030, USA | [phone] | [e-mail] | SimpliPhiPower.com
| 27 |
Figure 15.0 – Inverter Charge Rate Display
This completes the functional test. The internal set points have been pre-programmed for the PHI
3.8 Battery bank.
4.6 – AccESS Optional Components/Accessories Installation
4.6.1 – DC Coupled PV – 4.8 kW
The AccESS may be DC Coupled with a PV system up to 4.8 kW DC. Please refer to Schneider
Electric’s MPPT 80 600 installation manual and wiring diagrams for further information.
4.6.2 – Remote System Monitoring
Schneider Electric Conext ComBox
If purchased with the Conext Gateway or ComBox option, please refer to the Conext Gateway or
ComBox Owner’s Guide from Schneider Electric.
Network Requirements
Before making AC and DC connections, route communication cables through the raceways. For
easier identification, use a different color for each communications cable, or cable tags.
Connect communications cables to their components after AC and DC connections are made.
4.6.3 – Automatic Generator Start
Schneider Electric Conext AGS
If purchased with the Conext Automatic Generator Start, please refer to the Conext Automatic
Generator Start Owner’s Guide from Schneider Electric.
4.6.4 – Battery Monitoring
Schneider Electric Conext Battery Monitor
If purchased with the Conext ComBox, the Conext Battery Monitor is included on the exterior
door. This comes pre-wired and configured, but for more information, see the Conext Battery
Monitor Quick Start Guide.