PHI 3.8 24V & 48V Battery Manual

REV073019
SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93030, USA | [phone] | [e-mail] | SimpliPhiPower.com
| 16 |
5.0 – Programming
5.1 – Operating Parameters per Warranty
Although the PHI Batteries are capable of performing at very high rates and depths of discharge within a
very wide temperature range, in order to achieve extended life cycles and to comply with the Warranty,
the operating parameters, indicated in Tables 4.0 and 5.0 below, must be applied based on desired
Warranty/cycle life. Refer to the manufacturer-specific Integration Guide from SimpliPhi’s Product
Documentation web page for a complete list of settings: https://simpliphipower.com/product-
documentation/.
Table 4.0 – Warranty Operation Parameters
Recommended Operating Conditions for 10 Year Warranty
Equivalent to 80%
Retained Capacity
10,000 cycles
5,000 cycles
3,500 cycles
Discharge/Charge Rate
1,2
C/2
DoD
4
80%
90%
100%
Operating Temperature
°F (°C)
32 to 120 (0 to 49)
Programming Settings
for Ancillary Equipment
12V
24V
48V
12v
24V
48V
12V
24V
48V
Absorb / High Cut-Off
Voltage (V)
3
13.6
27.2
54.4
13.6
27.2
54.4
14
28
56
Absorb Time
1 Hour
1 Hour
1 Hour
Recharge / Low Cut-Off
Voltage (V)
3
12.6
25.1
50.2
12.4
24.8
49.6
12
24
48
The charge cycle should be programmed to 2 Stage / No Float. Utilizing a Float Charge is permissible
only in charge controllers’ programming. Refer to the relevant charge controller Integration Guide for
complete charge controller settings.
Table 5.0 – Operating Limitations
Notes / Operating Limitations for
PHI Batteries
PHI 3.8
PHI 2.9
PHI 1.4
PHI 730
Limitations by Model
24V
48V
24V
48V
24V
12V
24V
12V
Continuous
Discharge Rate (A)
45
37.5
45
28.5
28.5
40
14
28.5
Continuous Charge
Rate (A)
45
37.5
45
28.5
28.5
40
14
28.5
•
60A Discharge/Charge Rate (10 minutes maximum)
•
Levels are typically @ 25°C and may need adjusting at temperature extremes.
• When performing rapid deep charge/discharge cycles, the PHI Battery should be allowed to "rest" 15 mins in
between.