SimpliPhi Battery Manual
Table Of Contents
- PHI 3.8-MTM Battery Models
- and gain control of your own power.
- SimpliPhi Power helps you manage your power as a personal resource.
- power generation source – solar, wind, generator – on or off grid, and protects your home and mission-critical business functions from power outages and
- constraints, toxic coolants and the risk of thermal runaway. Safe lithium ferrous phosphate (LFP). No cobalt. No toxic hazards.
- (BMS) to create a portfolio of high performance, scalable and enduring energy storage solutions that provide power security, resilience and daily cycling for savings on your utility bill – all with a 98% efficiency rate.
- Table of Contents
- 1.0 – Introduction
- 2.0 – Safety
- 3.0 – Pre-Installation
- 4.0 – Installation
- 5.0 – Programming
- 6.0 – Troubleshooting
- Appendix A – PHI Battery Safety & Green Attributes,
- Appendix B – PHI Battery Bank Sizing Guide
- Appendix C – PHI Approved External Chargers
- Appendix D – PHI Legacy Battery Parameters
SIMPLIPHIPOWER.COM | 805-640-6700
REV202203161300
14
© SIMPLIPHI POWER, INC.
MISE EN GARDE: Ne pas associer les Batteries PHI avec d’autres marques et/ ou autres produits chimiques.
Ne pas mélanger les Batteries PHI provenant de différentes installations, différents clients ou différents sites
de travail. L’un ou l’autre de ces mélanges Annulera la Garantie.
4.3 – Mounting Hardware
PHI Battery mounting brackets (sold separately) are designed to secure one PHI 3.8-M Battery to a load bearing surface. The
brackets can be mounted directly to a wall or can be arranged on strut channels for ease of positioning (mounting hardware not
included). Mounting brackets should be mounted into load bearing beams, studs or solid materials with appropriate fasteners. A
qualified installer should be familiar with accomplishing this with the appropriate load bearing requirements. SimpliPhi Power is
not liable for damage caused by inappropriate installation mounting of brackets. Refer to Figure 2.0 for PHI Battery and
mounting bracket dimensions and weights.
During mechanical testing, individual PHI 3.8-M Mounting Brackets were exposed to 200 pounds each of downward pressure
along the bracket’s outer edge. During this test, a deflection of approximately 30 thousandths of an inch was measured. Bracket
sets are designed to hold one PHI 3.8-M Module with a weight of 86 pounds.
4.4 – Dimensions and Weight
Table 3.0 – Specifications: PHI 3.8-M Battery & PHI 3.8-M Battery w/ Mounting Bracket
PHI 3.8-M Battery PHI 3.8-M Battery/ w/ Mounting Bracket
Width 13.5’’ 13.7” (18” with mounting flanges)
Height 15.5’’ (including 1.5” terminal height) 15.75” (including 1.5” terminal height)
Depth 8” 9”
Weight 86 Pounds 94 pounds
Figure 2.0 – PHI 3.8-M Mounting Bracket Assembly
CAUTION: Do not combine PHI Batteries with other brands or chemistries. Do not mix PHI Batteries from
different installations, clients or job sites. Either of these combinations will Void the Warranty.