Magnum Energy Integration Guide

REV070219

| 4 |

1.0 – Introduction

This integration guide covers the recommended set up and configuration of Magnum Energy equipment

for optimizing performance with SimpliPhi PHI 3.8 kWh batteries. More information on SimpliPhi products

can be found on our website: https://simpliphipower.com/.

Magnum Energy offers many products which are too numerous to be covered here. The specific Magnum

Energy products covered in this guide include, but are not limited to:

• MS 4024 PAE inverter/charger

• MS 4448 PAE inverter/charger

• PT-100 charge controller

• ME-ARC Remote Control

• ME-RTR Remote Control

• ME-RC Remote Control (basic unit with no support for configuring the PT-100 charge

controller)

For additional information about the Magnum Energy products covered in this guide, refer to the following

documentation:

• Magnum Dimensions PT-100 MPPT Charge Controller

• Magnum Energy ME-RTR Router Control Owner’s Manual

• Magnum Energy ME-ARC Advanced Remote Control Owner’s Manual

2.0 – Charge Controller and Inverter Settings

Magnum Energy has performed qualification testing of the PHI 3.8 kWh battery with their equipment. Per

their testing and recommendations, the following parameters (refer to Section 4.0) have been validated.

Magnum Equipment must be programmed using a Magnum Remote Control, preferably the ME-ARC,

ME-RTR, or ME-ARTR model.

Note that the ME-RC model remote does not allow for any monitoring or adjustments to Magnum’s charge

controller (the PT-100).

See Remote Compatibility info from pg. 42 of the PT-100 manual:

Table 4.0 – Remote Compatibility Version

Remote Models

Version with PT Menus

Version Required for Stacking PTs

ME-ARC

 Version 4.0

 Version 2.0

ME-ARTR

 Version 4.0

ME-RC

 Version 2.6

ME-RTR

 Version 2.0

More information on Magnum Energy products can be found on their website: http://www.magnum-

dimensions.com/.