Victron Energy Integration Guide

REV202103041459
SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93023, USA | [phone] | [e-mail] | SimpliPhiPower.com
| 9 |
Charge Efficiency
95%
SoC when Bulk Finished 95%
Notes:
•
1.
Per PHI 3.8 Battery – These settings are calculated by multiplying the nominal per battery value times the # of
batteries.
• Levels are typical @ 25°C and may need adjusting at temperature extremes.
• When performing rapid deep charge/discharge cycles, the PHI Battery should be allowed to "rest" 15 minutes in
between.
• Always refer to the SimpliPhi Power Manual and Warranty for the specific PHI Battery model.
4.3 – Victron BMV-700 Programming Settings
Table 2.0 - Settings for SimpliPhi PHI 3.8 kWh 24V / 48V Battery w/Victron BMV-700 Battery Monitor
Victron BMV-700 Settings
PHI 3.8 kWh 24V / 48V
Quick Start
Battery Capacity
1
(Ah)
151Ah per PHI3.8 24V; (302Ah for 2, 453Ah for 3)
75Ah per PHI3.8 48V; (150Ah for 2, 225Ah for 3)
Charged Voltage (V)
26.5 / 53.2
Tail Current (%)
8 / 4
Charge Detection Time (minutes) 1
Peukert Exponent 1.05
Charge Efficiency Factor (%)
98
Current Threshold (A)
0.1
Time to go Averaging Period (minutes)
3
Notes:
•
1.
Per PHI 3.8 Battery – These settings are calculated by multiplying the nominal per battery value times the # of PHI
Batteries.
• Levels are typical @ 25°C and may need adjusting at temperature extremes.
• When performing rapid deep charge/discharge cycles, the PHI Battery should be allowed to "rest" 15 minutes in
between.
• Always refer to the SimpliPhi Power Manual and Warranty for the specific PHI battery model.
CAUTION: When battery quantities change, the capacity current settings must be reassessed.