Victron Energy Integration Guide

SimpliPhi Power, Inc. | 3100 Camino Del Sol | Oxnard, CA 93023, USA | [phone] | [e-mail] | SimpliPhiPower.com
| 10 |
4.4 – Inverter / Charger Settings
The program settings for the PHI 3.8 Batteries with Victron Inverter / Charger products are outlined below.
Table 3.0 - Settings for SimpliPhi PHI 3.8 kWh 24V / 48V Battery w/Victron Inverter / Charger
Program Settings for SimpliPhi Model 3.8 - 24V / 48V with Victron Inverters / Chargers
Phoenix VE.Direct Inverters
Victron Connect
Static Low Voltage Cutoff
Output Voltage
230V
Output Frequency
50Hz
Dynamic Cutoff
OFF
Low Battery Shutdown
2
5.1V / 50.2V
2
4.8V / 49.6V
2
4V / 48V
Low Battery Restart & Alarm
27V / 54V
Charge Detect 27V / 54V
ECO Mode Wake-up Minimum Power
15W
ECO Mode Search Interval
2.5S
Victron Connect
Dynamic Low Voltage Cutoff
Enable Dynamic Cutoff
ON
Battery Type
Custom
Battery Capacity
1
75A per PHI3.8 48V
Voltage for Discharge 0A
25.1V / 50.2V
24.8V / 4
9.6V
2
4V / 48V
Voltage for Discharge 8A
Voltage for Discharge 23A
Voltage for Discharge 66A 25V / 50 V
24.6V /
49.1V
23.8V / 47.5V
MultiPlus & Quattro
Inverter Chargers
80% DoD
90% DoD
100% DoD
VE Configure
General Tab
SoC when Bulk Finished
95%
Total Battery Capacity
1
151Ah @ 24V / 75
Ah @ 48V: per battery
Charge Efficiency
95%
VE Configure
Inverter Tab
DC Input Low Shut-Down
25.1V / 50.2V 24.8V / 49.6V 24V / 48V
DC Input Low Restart
25.7V / 51.5V
DC Input Low Pre-Alarm 25.5V / 51V
VE Configure
Charger Tab
Battery Type
Lithium
Lithium > Yes
Lithium Iron Phosphate
Absorb Voltage
28V / 56V
Float Voltage
27V / 54V
Charge Current (C/2)
1
Repeated Absorb Time
.1 Hour (6 Minutes)
Repeated Absorb Interval 7 Days
Absorb Time
.1 Hour (6 Minutes)
Notes:
• 1.
Per PHI 3.8 Battery – These settings are calculated by multiplying the nominal per battery value times the # of batteries.
• Levels are typical @ 25°C and may need adjusting at temperature extremes.
• When performing rapid deep charge/discharge cycles, the PHI Battery should be allowed to "rest" 15 minutes in
between.
• Always refer to the SimpliPhi Power Manual and Warranty for the specific PHI Battery model.
2
5.1V / 50.2V
2
5.1V / 50.2V
2
4.8V / 49.6V
2
4.8V / 49.6V
2
4V / 48V
2
4V / 48V
75A @ 24V DC / 37.5VDC @ 48V: per battery
REV202103041456