SimpliPhi Battery Manual
Table Of Contents
- PHI 3.8-MTM Battery Models
- and gain control of your own power.
- SimpliPhi Power helps you manage your power as a personal resource.
- power generation source – solar, wind, generator – on or off grid, and protects your home and mission-critical business functions from power outages and
- constraints, toxic coolants and the risk of thermal runaway. Safe lithium ferrous phosphate (LFP). No cobalt. No toxic hazards.
- (BMS) to create a portfolio of high performance, scalable and enduring energy storage solutions that provide power security, resilience and daily cycling for savings on your utility bill – all with a 98% efficiency rate.
- Table of Contents
- 1.0 – Introduction
- 2.0 – Safety
- 3.0 – Pre-Installation
- 4.0 – Installation
- 5.0 – Programming
- 6.0 – Troubleshooting
- Appendix A – PHI Battery Safety & Green Attributes,
- Appendix B – PHI Battery Bank Sizing Guide
- Appendix C – PHI Approved External Chargers
- Appendix D – PHI Legacy Battery Parameters
SIMPLIPHIPOWER.COM | 805-640-6700
REV202203161300
21
© SIMPLIPHI POWER, INC.
CAUTION: Do not reverse polarity. Use a voltmeter to check polarity before making connections to the
battery terminals. Reversing polarity will Void the Warranty.
MISE EN GARDE: Ne pas inverser la polarité. Utiliser un voltmètre pour vérifier la polarité avant de se
connecter aux bornes de la batterie. Inverser la polarité Annulera la Garantie.
CAUTION: PHI Batteries should be installed, wired and commissioned by a certified installer or professional
electrician who is familiar with general electrical safety precautions and specific regional code requirements.
MISE EN GARDE: Les Batteries PHI devraient être installées, câblées et mises en service par un installateur
agréé ou un électricien professionnel qui connaît les mesures de sécurité électriques générales et les
exigences particulières du code régional.
Figure 9.0 - Interconnecting Busbar Placement on PHI Battery Threaded Stud
Helpful Tips:
• The interconnecting busbars’ ratings should match or exceed the PHI Battery bank’s total surge rating.
• Busbars for paralleling more than two or three PHI Batteries can be sourced from Storm Power Components: https://
stormpowercomponents.com/.
• SimpliPhi recommends paralleling PHI Batteries using interconnecting busbars (not battery cables) for PHI Battery Banks
consisting of more than 20 PHI Batteries for a cleaner installation.
• Size the battery cables leading from the interconnecting busbars to the Balance of System equipment using the National
Electrical Code’s Conductor Ampacity tables.
4.7 – Battery System Commissioning