SimpliPhi Battery Manual
Table Of Contents
- PHI 3.8-MTM Battery Models
- and gain control of your own power.
- SimpliPhi Power helps you manage your power as a personal resource.
- power generation source – solar, wind, generator – on or off grid, and protects your home and mission-critical business functions from power outages and
- constraints, toxic coolants and the risk of thermal runaway. Safe lithium ferrous phosphate (LFP). No cobalt. No toxic hazards.
- (BMS) to create a portfolio of high performance, scalable and enduring energy storage solutions that provide power security, resilience and daily cycling for savings on your utility bill – all with a 98% efficiency rate.
- Table of Contents
- 1.0 – Introduction
- 2.0 – Safety
- 3.0 – Pre-Installation
- 4.0 – Installation
- 5.0 – Programming
- 6.0 – Troubleshooting
- Appendix A – PHI Battery Safety & Green Attributes,
- Appendix B – PHI Battery Bank Sizing Guide
- Appendix C – PHI Approved External Chargers
- Appendix D – PHI Legacy Battery Parameters
SIMPLIPHIPOWER.COM | 805-640-6700
REV202203161300
20
© SIMPLIPHI POWER, INC.
CAUTION: Again, no material (such as a washer) should be placed between the current carrying terminal and
the interconnecting busbars. The interconnecting busbars are placed on the PHI Batteries’ terminals first,
then the flat washer, lock washer, and nut are secured to the terminal posts
MISE EN GARDE: Encore une fois, aucune pièce (comme une rondelle) ne doit être placée entre la borne de
courant et la cosse du câble, ou bien le jeu de barres. Le jeu de barres d’interconnexion sont d’abord placées
sur les bornes des Batteries PHI, puis la rondelle suivi de la rondelle d’arrêt et enfin de l’écrou, le tout fixé à la
borne.
4.6.3 – Parallel Wiring Batteries with Threaded Studs using Interconnecting Busbars
PHI Batteries can be paralleled using common bussing directly attached to the batteries’ terminals. Best practice involves
wiring the battery leads to opposite ends of the busbars, as illustrated in Figure 8 below. Interconnecting busbars for
paralleling either two (SKU #BB-2) or three (SKU #BB-3) PHI batteries with threaded studs are available from SimpliPhi at
an additional cost.
Figure 8.0 - PHI Battery Wiring Using Interconnecting Busbars