MidNite Solar Integration Guide

REV0411
18
SimpliPhi Power, Inc. | 420 Bryant Circle | Ojai, CA 93023, USA | [phone] | [e-mail] | SimpliPhiPower.com
| 6 |
4.0 – Program Settings for PHI 3.5 Battery
In order to maintain the Warranty, it is critical to ensure that the appropriate settings for the desired
Warranty are programmed in all of the system components. This section will cover the basic concepts and
settings for Midnite Solar equipment.
4.1 – Depth of Discharge
In order to optimize performance and the life of your system and PHI batteries, SimpliPhi recommends
programming the equipment settings for 80% Depth of Discharge (DoD). This qualifies for the SimpliPhi
10-year / 10,000 cycle Warranty on the PHI batteries. Greater DoD is possible, but will result in reduced
cycle life. Refer to the PHI 3.5 kWh Battery Warranty to compare DoD settings and the associated
Warranty.
CAUTION: If a firmware update is executed on Midnite Solar equipment, ALL the settings must be
reverified. The programmed settings shown in the following table must be applied based on
desired Warranty/cycle life. The recommended is 80% Depth of Discharge.