SimpliPhi Battery Manual
Table Of Contents
- 1.0 – Introduction
- 2.0 – Safety
- 2.0 – Pre-Installation
- 4.0 – Installation
- 5.0 – Programming
- 6.0 – Troubleshooting
- Appendix A – PHI Battery Safety & Green Attributes, Certifications
- Appendix B – PHI Battery Bank Sizing Guide
- Appendix C – PHI Approved External Chargers
- Appendix D – PHI Legacy Battery Parameters
REV202010211307© SIMPLIPHI POWER, INC.
SIMPLIPHIPOWER.COM | 805-640-6700
20
4.6.3 – Parallel Wiring Batteries with Threaded Studs using Interconnecting Busbars
PHI Batteries can be paralleled using common bussing directly attached to the batteries’ terminals. Best practice involves
wiring the battery leads to opposite ends of the busbars, as illustrated in Figure 8 below. Interconnecting busbars for
paralleling either two (SKU #BB-2) or three (SKU #BB-3) PHI batteries with threaded studs are available from SimpliPhi at
an additional cost.
Figure 8.0 - PHI Battery Wiring Using Interconnecting Busbars
MISE EN GARDE: Encore une fois, aucune pièce (comme une rondelle) ne doit être placée entre la borne de
courant et la cosse du câble, ou bien le jeu de barres. Le jeu de barres d’interconnexion sont d’abord placées
sur les bornes des Batteries PHI, puis la rondelle suivi de la rondelle d’arrêt et enn de l’écrou, le tout xé à la
borne.
CAUTION: Again, no material (such as a washer) should be placed between the current carrying terminal and
the interconnecting busbars. The interconnecting busbars are placed on the PHI Batteries’ terminals rst,
then the at washer, lock washer, and nut are secured to the terminal posts