SimpliPhi Battery Manual
Table Of Contents
- 1.0 – Introduction
- 2.0 – Safety
- 2.0 – Pre-Installation
- 4.0 – Installation
- 5.0 – Programming
- 6.0 – Troubleshooting
- Appendix A – PHI Battery Safety & Green Attributes, Certifications
- Appendix B – PHI Battery Bank Sizing Guide
- Appendix C – PHI Approved External Chargers
- Appendix D – PHI Legacy Battery Parameters
REV202010211307© SIMPLIPHI POWER, INC.
SIMPLIPHIPOWER.COM | 805-640-6700
19
Figure 7.0 – Lug Placement on PHI Battery Threaded Stud
MISE EN GARDE: Aucune pièce (comme une rondelle) ne doit être placée entre la borne de transport de
courant et la cosse de câble ou bien le jeu de barres d’interconnexion. Cela Annulera la Garantie.
MISE EN GARDE: Une étincelle peut apparaître lors de la connexion des ls aux bornes de la Batterie PHI.
Assurez-vous que le disjoncteur intégré à la batterie est en position OFF pour minimiser le risque de choc ou
d’étincelles lors de l’installation du système.
CAUTION: No material (such as a washer) should be placed between the current carrying terminal and the
cable lug or interconnecting busbar. Doing so will Void the Warranty.
CAUTION: Spark may be present when connecting wires to PHI battery terminals. Be sure the battery’s built-
in circuit breaker is in the OFF position to minimaze the risk of shock or sparks during system installation.