SimpliPhi Battery Manual

REV202010211307© SIMPLIPHI POWER, INC.
SIMPLIPHIPOWER.COM | 805-640-6700
15
4.5.2 – Torque Value for Batteries with Threaded Studs
PHI Batteries with threaded stud terminals have a torque specication of 160 in-lbs. (13.3 ft-lbs.).
Figure 3.0 – PHI 3.8 Threaded Stud
MISE EN GARDE: Ne pas desserrer le gros écrou en laiton à la base des bornes; cela endommagerait la
Batterie PHI et Annulerait la Garantie.
CAUTION: Do not attempt to loosen the large brass nut at the base of the terminals; doing so will damage the
PHI battery and Void the Warranty.
4.5.3 –Batteries with Anderson Connectors
The smaller PHI Battery sizes (such as the PHI 1.4 and PHI 730) are equipped with SB 50 Anderson connectors utilizing P/N
5900 #6 HD contacts.
• 12V connections are YELLOW
• 24V connections are RED
To avoid any spark or electrical event when connecting batteries with Anderson Connectors, turn the accompanying
equipment off, connect cables with appropriate battery mating connectors to the equipment, and then make nal
connections via connectors to the batteries before turning on the system’s accompanying equipment.
4.5 – PHI Battery Connection Terminals
4.5.1 – Batteries with Threaded Studs
The PHI 3.8 Battery is equipped with two 3/8’’ (10 mm) threaded studs with a lock washer and nut. The red colored high
temperature molded insert connection is for the positive lead. The black colored high temperature insert connection is for
the negative lead.
Water Resistant Cable Boots are also included and will be in place when your units arrive. The boots are to be placed over
the cable terminations and will stretch to form a water-resistant seal around the base of the molded inserts and terminal
connections.
Threaded Studs = 3/8” (10mm)
Torque Value = 160 in-lbs