SimpliPhi Battery Manual

REV202010211307© SIMPLIPHI POWER, INC.
SIMPLIPHIPOWER.COM | 805-640-6700
14
4.3 – Mounting Hardware
PHI Battery mounting brackets (sold separately) are designed to secure one PHI 3.8 Battery to a load bearing surface. The
brackets can be mounted directly to a wall or can be arranged on strut channels for ease of positioning (mounting hardware not
included). Mounting brackets should be mounted into load bearing beams, studs or solid materials with appropriate fasteners.
A qualied installer should be familiar with accomplishing this with the appropriate load bearing requirements. SimpliPhi Power
is not liable for damage caused by inappropriate installation mounting of brackets. Refer to Figure 2.0 for PHI Battery and
mounting bracket dimensions and weights.
During mechanical testing, individual PHI 3.8 Mounting Brackets were exposed to 200 pounds each of downward pressure along
the bracket’s outer edge. During this test, a deection of approximately 30 thousandths of an inch was measured. Bracket sets
are designed to hold one PHI 3.8 Module with a weight of 86 pounds.
4.4 – Dimensions and Weight
Table 3.0 – Specications: PHI 3.8 Battery & PHI 3.8 Battery w/ Mounting Bracket
MISE EN GARDE: Ne pas associer les Batteries PHI avec d’autres marques et/ ou autres produits chimiques.
Ne pas mélanger les Batteries PHI provenant de différentes installations, différents clients ou différents sites
de travail. L’un ou l’autre de ces mélanges Annulera la Garantie.
CAUTION: Do not combine PHI Batteries with other brands or chemistries. Do not mix PHI Batteries from
different installations, clients or job sites. Either of these combinations will Void the Warranty.
PHI 3.8 Battery PHI 3.8 Battery/ w/ Mounting Bracket
Width
13.5’’
13.7” (18” with mounting anges)
Height 15.5’’ (including 1.5” terminal height) 15.75” (including 1.5” terminal height)
Depth 8” 9”
Weight 86 Pounds 94 pounds
Figure 2.0 – PHI 3.8 Mounting Bracket Assembly