SimpliPhi 1.3kWh Warranty

SimpliPhi Power, Inc. | 420 Bryant Circle | Ojai, CA 93023, USA | [phone] | [e-mail] | SimpliPhiPower.com
| 5 |
Section 2.0 – SimpliPhi Power Guide for Operating
Parameters
Although SimpliPhi batteries are capable of performing at very high rates and depths of discharge within a
very wide temperature range, in order to achieve extended life cycles and to comply with the Warranty,
the following guidelines should be followed:
Table 1.0
Operating Parameters for 5 Year Warranty
Equivalent to 80% Retained Capacity
10,000 cycles
5,000 cycles
3,500 cycles
Discharge/Charge Rate
1,2
C/2
Depth of Discharge (DoD)
4
80%
90%
100%
Operating Temperature °F (°C)
32 to 110 (0 to 43)
32 to 120 (0 to 49)
32 to 120 (0 to 49)
Programming Settings for Ancillary Equipment
PHI Battery Voltage
12V
24V
12V
24V
12V
24V
High Cut-Off Voltage (V)
14.5
29
14.5
29
14.5
29
Absorb (V)
3
14
28
14.4
28.8
14.4
28.8
Recharge (V)
3,4
12.65
25.3
12.65
25.3
12.65
25.3
Low Cut-Off Voltage (V)
3
12.55
25.1
12.4
24.8
12
24
Table 2.0
Operating Limitations for
PHI 1.3 Batteries
1
Limitations by Model
12V
24V
Continuous Discharge Rate (A)
40
26
Continuous Charge Rate (A)
40
26
•
1. Continuous charge/discharge rate limitations vary per PHI battery model. Refer to Table 2.0.
•
2. 60A Discharge/Charge Rate (10 minutes maximum)
•
3. Levels are typically @ 25°C and may need adjusting at temperature extremes.
•
4. Recharge voltage is typically set nominally higher than LBCO to initiate recharge before cut-off. Some
applications (i.e. backup only) may desire settings these levels higher to insure minimum SoC in the event of
primary power outage.
• When performing rapid deep charge/discharge cycles, the PHI 1.3 Battery should be allowed to "rest" 15 mins in
between.